Search results

Just started vaping again. using my old setup of 510 atomizer and dripping. using my old super t mods. what do people use now? kick? juice holders on the ends? lol...its been a while.. thinking about putting in an order for some new super t stuff with the sale goin on and I'm kinda clueless...

P16 fires about 87% of the time. yes exactly 87% lol i thought it was dirty so I cleaned it all up and still the same thing. I am using 5 brass orings (for a real short button press which a prefer) on it so that may be contributing? i just started vaping again. (I was with no cigs OR vaping...

this may have been covered before..not sure though. I have those old brass super t tips. is it bad for you? should I clean my tips with brasso and rinse them in water? i feel as if I should clean any old tranished brass and use dish soap and dry and it might be fine. your thoughts?

I want something that looks like a cig, takes 510 attys and will perform at true 3.7v. the batt life will suffer but I want it to perform like a 3.7v mod. most e-cigs I've tried like this are "weaker" than my 14500 batt mod. i want something to match the power. batt life doesn't...

2 14500 AW li-ion protected. batteries. used for a few weeks. stored for a month or so at 40% charge. =) I took great care of them... never over charged or underdischarged. lots of life left in them. they are the same as the onces in the pics. $17 shipped. us only. lower 48. paypal only...

I'm wonding how well the cr123a protected AW fits the pila charger with the 15mm spacer from lighthound.com work well? heres link to 15mm spacer I'm wanting http://www.lighthound.com/15mm-Charg...inum_p_25.html heres link to batts I may get...

I want to buy some.

I looks like I'm getting some rust at the tip of the Supter T t-tip 510 Stainless Steel. :( I don't drip "through" the tip (I take it off to drip) and I drain it after every use top facing up. Anyone else have this happen? -Picture added.

Any advantages over 18650 vs. 14500 besides obvious bigger Mah capacity? Hit harder? etc?

I prefer 14500 batts. going to make bottom button protege?

any one tried these? are they any good compaired to super t's t-tips? (i'll maybe get one with my bulk 510 atty purchase) edit: are they short like the super t shortys? they look kind of little in the pics

Looking for a good slim case for protege to on the go. Would be a plus if it has zipper for attys. Soft case or hardshell.

I use joye 510's. all of my attys perform differently new. most of them perform poorly. I've tried over 6 attys. they are all just so inconsistent and I'm getting too many weak ones that just arn't acceptable. maybe its the juice I'm using...idk? any one having similar experience?

I use 14500 ultrafire Protected. the protected are longer than unprotected. I have about 10+ batts so a case that holds a lot would work for me. It doesn't have to be portable. where to find a case that will fit these?

Can I leave my 14500 batts in the car? when is the temperature too high or too low for li-ions? (feel free to move if this thread is in the wrong section)

I own the tenergy and trustfire multi-charger. are there any better ones out there? they seem kinda cheap but so far they get the job done. Looking to upgrade.

I have Meguairs tech wax, brasso and mothers wax mag alu. I've yet to try them but I used the meguairs on my protege and it protected it very well from scratches. I think I should have had some deep scratches. Feel free to post online places to buy to help out other vapers...

Why no vent holes on Pure Smoker PVs?

--At this point, it seems like the placement of the holes and how many holes seems logical for safety purposes on the super T S6 and other Super T models. Why? Becuase you don't want the gasses trapped in the tube and have the atty shoot at your face. (as you many already know) and other...

Hows it hit at 3.7v? I prefer 3.7 and would probably only use it at 3.7v if I get one in the future.