Search results

Is it safe to use the Buzz voltmeter adapter on other devices? I would like to try and establish a baseline of voltages on other devices using different atties, cartos, juices, etc. that I currently enjoy.

I have a Tornado battery that the light will light up when you push the switch, but no power goes out to the atty (tested with ohm/volt meter). Any ideas?

Has anyone considered using a dead eGo/Tornado battery connector, switch, led to make a box mod. It might look really good with the atty cone attached.

I was wondering if any of you PS geniuses could help me to change the graphic below to read "Chuck" "Perfection".

For my Xhaler friends I came up with an 801 atty blue foam drip mod today. You can check it out in the Cartridge Mods section: 801 Atomizer Cartridge Drip Mod (801ACDM) Drew, this one is for you! No more tail piping... Add a t-tip and it's golden. Luke

Cut two pieces of rinsed and dried blue foam approximately 18mm long and 12mm wide. Put a drop or two of e-liquid directly on the atomizer bridge, then slide the two pieces of blue foam, side-by-side lengthwise, down into the barrel of the 801 atomizer. (I am using a high bridge atomizer)...