Search results

Got the ni200 occ heads for the subtank from vaporshark. Great buy to go with the flask. Amazing flavor and not an single dry hit. Temperature control working fine. I wish they were more common and not only on vapor shark's website.

Lol, getting that a lot. Got this key lime cookie juice from ripe vapes and was amazing, now I can't taste anything lol.

Seems to be the flask then. It fit just ok on my ipv mini. Sad as the Venturi is a great flavor chaser. May I ask what other rda you went for?

Hi, I bought a venturi RDA at my b&m shop and it didn't fit my vapor flask v2.1, matter of fact didn't fit any of the vapor flasks at the shop. Then they brought more Venturi's and none of then fit them either. They would screw a couple of turns, but then nothing more. Bad batch? Have anybody...

I'm loving the rba section on the mini way better than the occ ones. No dry hits and chain vaping at 30w on pwm mode on the ipv mini. I went through the pre-installed occ head pretty fast, however I suspect it's because I was using the ipv mini in dc-dc mode and it cannot buck down voltages in...

I'm using an imren one too and all ok here. Is yours a red one?

Hope they improve the usb connector. A few people reporting it being flimsy on the current mini.

He told me is "cutting" it tonight...whatever that means.

You meant the are going to start pumping out sx mini's with the new joules protection board in March, or just the chipset? Would love to wait and get a sx Mini with this new board.

So are they going to produce a sx Mini with this board our they're only going to sell the chipset? Trying to decide if to wait....

You're right. I emailed him and he confirmed. He also said would look into PWM and DC-DC modes.

I thought pbusardo was going to review it, but nothing yet. Didn't it win the poll for next review?

Please keep us updated on how they handle your warranty. Was planning on buying it from them...

Not at all, what I meant is for "us owners of these devices with these chips" lol.

For other products, not for our chip. Check Yihi's website. Our chipset isn't firmware upgradable unfortunately. http://www.yihiecigar.com/products_info/YiHiEcigar-SX130-286852.html

I thought yihi and p4u stated many times this isn't firmware upgradeable at all. Seems to me your b&m guy is wrong, sorry.

Look at the positive side, it's not a cigarette anymore and you're not burning down your house! [emoji4]

I have not touched the center pin at all. Didn't need to. Just didn't over tighten the tank. Just mentioned that to him as I assumed could be adjusted, since he has to almost fully unscrew his tank. I stand corrected. Anyways I found the sweet spot when tightening my tanks and all read correctly...

Wow, mine isn't as bad as yours. Mine is still flush, all it takes for mine is not to over tighten it. You may want to try adjust the screw inside. Definitly not a waste of time on mine. Consistent ohm readings all day long.

Tank screwed a little less tight and stays at 0.5ohms all day long.