Search results

  1. L

    24mm mech mod with magnetic switch?

    oros v2
  2. L

    0.08 ohm coil build

    ^There is no point building that low on a regulated device. Just add one or two more wraps to you coils. Adding surface area an increase flavor.
  3. L

    For an RTA, what's the best # of wraps and ID for wicking/flavor ?

    Generally a bigger diameter would create a more restrictive airflow compared to a smaller diameter coil. **IN A TANK I usually build bigger diameter coils because i build super low and small diameter coils holds less cotton and is more likely to go dry on me. And I do so because I want clouds...
  4. L

    1st Clapton Coil Build

    Try using a higher gauge wrap wire, normally 36 gauge outter wire is standard for mechanical devices. Also try nichrome instead of kanthal, ramps up way faster on mechs.
  5. L

    Where's the Flavour?!

    as oppose to a higher gauge and closing the airflow, try a lower gauge with opened airflow. Depending on your device, a 0.5 ohm build with 26g nichrome around a 3mm diameter gives off great flavor around 50 watts.
  6. L

    Need Help With Alien Clapton Coils

    invest in a four jaw drill chuck, way easier to keep the wires parallel.
  7. L

    Batteries loose voltage when idle

    Hello all, My set up is oros v2 with 0.12 ohm build running HB6. Recently I have noticed that the HB6 would loose voltage when idle sitting inside the mod. And that leaves me wonder if my batteries have gone bad. I would do maybe 4 pulls and then let it sit for about 2 hours and when I come...
  8. L

    YOUR top 3 atomizers for cloud chasing!

    As long as your atty has enough airflow, only the type of build and or power you push through the coils matters for clouds. 1. mutation x v2/v3 with a chuff cap 2. subzero rda 3. mako shorty with a chuff
  9. L

    RDA Twisted messes

    The twisted messes is not really known for flavor. If you really want to kick the flavor up a notch you have several options: increase the surface area of your build, dialing up the power, or build lower resistance coils if you are using a mechanical device. If you use a regulated device, you...
  10. L

    RDA NEW 24 mm mech in mail, need a 24 mm dripper

    i would get a subzero 24mm, even with the airflow wide open, it still gives a ton of flavor.
  11. L

    new to series builds need some help

    wrap your coils in a bigger diameter driver like a 3.5mm and dual it up
  12. L

    RDA Best RDA for beginners

    it might be the taste of kanthal wire, some taste it and some dont in my experience. I do, so I have always used nichrome for my builds
  13. L

    Geekvape Griffin builds

    i use 28g fused claptons x 36g all nichrome, 7 wrap around a 2.5mm driver. Near zero ramp up, wicks great and no dry hits.
  14. L

    RDA Buddha

    goon,temple, tugboat 24, mason rda, all very fine atties.
  15. L

    RDA Best kanthal build in the MAGMA RDA for flavour?

    Typically a 0.8-0.6 ohm build is perfect for flavor. As you go below 0.5, the vape will just get hot because of the small airflow. It's really personal preference how hot you want your vape to be. But 0.8 should be a good reference and a starting point.
  16. L

    the life of a Clapton and fused Clapton coil

    I have a different experience. I am like you, I replace coils because i get bored with them. However, for the times that I have ran fused claptons, I found that they usually last no more than 3 weeks. Depending on the type of wire you are using, the more you dry burn your coils, the more the...
  17. L

    New Mech Tube Recommendations?

    Hello, Recently dropped my oros v2 and the button is all screwed up. Looking to acquire another mechanical tube mod. Currently looking at the roundhouse by kennedy. Budget is anything below 150. Any inputs would be greatly appreciated. Thanks
  18. L

    Recommendations on RTA

    goblin v2, and also zypherus v2. if you want crazy airflow, get the bft by ohmega. You can win a cloud comp with that crazy tank, not an overstatement.
  19. L

    Fused Clapton wire

    lightning vapes sells different variations of fused claptons wire for cheap
  20. L

    Most Efficient Coil Build for Mechs ?

    I think you pretty much have an idea of what you are gonna use in the first place. Its personal preference, if you dont want to go below 1 ohm, there arent much options to work with more than 28 gauge.
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu