Search results

I'm very partial to the Goblin Mini V2 and V3. Excellent flavor and vapor. Definitely more challenging to wick than some of the others but it's still pretty simple.

I have the Rig V2 with the Roughneck V2. I use it whenever I work outside because it's so solid I don't have to worry about it if I drop it. I'm not a fan of the deck but it works just fine.

I second the Hadaly for flavor. For clouds, Double Vision and Twisted Messes.

The newest Goblin Mini (V3) comes with both decks. I use 100% VG unflavored in mine and chain vape without issue. You just need to use a little bit less cotton and it will wick just fine.

I use the Goblin Mini V2 and V3s on my Pico and they suit all of your needs. The clones from Fasttech are pretty good and cheap as well.

Even with a 510 pin in the mod, you should test all of the premade coils on a regulated mod or ohm meter before attaching them to a mech mod. Some coils come from the factory shorted out and will cause a battery to vent.

Like everyone above said, you can use it with no issues. My only concern would be that once in a great while, factory coils are shorted from the factory and if you were to install a new coil and put it right on to the mechanical mod, you would have a battery vent in your hand. If you are going...

Even after all of these new innovations, I'm still partial to my Goblin Minis. Whether it be the V1, V2, or V3, I always go back to them.

I think you're going way too high with the wattage. I use a dual 28g build in my Goblin Mini V2s and V3s that comes out to about .76 ohms and I only go up to 35 watts maximum. Like everyone else said, try a lower wattage and work your way up. You'll probably get better results.

I've personally had great luck with MyVaporStore, Mount Baker Vapor, EJuiceMafia, and Fasttech (other than their painfully slow shipping times, their service is awesome).

Does anyone know of any mods that will fit 30mm RTAs without the obnoxious overhang? I've been using a VCMT on a RX200 and I've finally had enough of the little overhang. It's time for a new mod that looks right with the big tanks on it.

I'll second (or third or fourth) the Pico and Goblin Mini v2 or v3. I started with one for a work mod and now I've ordered a few more just to keep around the house in different places. Looks good and vapes great.

This is what I use. It's from Shane Diego Leather.

Just like sawlight said, it's a software issue. My Pico does it every time I change the battery and every once in a while when I first turn it on in the morning.

What tanks are on the 4Nine and the Atto? They look perfect on there.

The TFV8 Baby will not fit the Pico. The Pico can only take 22mm tanks so be aware of that when you are making your purchase.

I always sub ohm 9mg unflavored. Some times I'll bump it up to 12mg if the 9mg isn't doing it for me that day.

I don't see any issues with using dual coils on one battery. My current work setup is a Pico with a Goblin Mini V2 with a .75 ohm dual 28g build. I'm using Samsung 25R batteries and get almost a day and a half on one battery at between 25 and 35 watts.

I vape about 7ml of 9mg during the week and closer to 15-20ml on the weekends if I'm just sitting around the house.

Personally, I prefer the Twisted Messes or Double Vision when it comes to clouds. Monster build deck for excessive amounts of wire. I use those on my series boxes.