Search results

  1. excalibur-x

    Coppervape's Skyline Clone

    Skyline is on my radar for quite some time, and even thou I don't have it I am certain Spica and Skyline are very similar RTA. In High End RTA thread I posted some photos and my experience with Spica, so if anybody interested in Spica should check it out. Some people posted leaking/gurgling...
  2. excalibur-x

    Picture of Your Setup Part 3!

    Spica on top of VT75 filled with some vanilla caramel tobacco. Together with some Likya white wine at sunset, well, it doesn't get much better than this. Sent from my LeTv 1 Pro using Tapatalk
  3. excalibur-x

    Gentlemen's corner

    My knowledge of vaping progressed so much I can say I will never again go back to smoking. My daily needs are completely satisfied and I have no desire to grab Marlboro Lights. I much prefer many of my DIY liquids. But on rare occasions I still yearn for that taste I got when smoking cigars or...
  4. excalibur-x

    Eden Mods Rose 3

    Is it possible to buy original air restrictor for Rose 3? I got little spoiled with Spica and 2mm restrictor so today I wrapped 26/30 SS clapton around 2mm rod and somehow stashed in to the 3.5mm air hole. With 28gauge SS316 2.5mm ID 8 wraps Rose 3 tastes incredible on 1 hole, if I close her...
  5. excalibur-x

    Spica RTA by Sirius Mods (mtl)

    Raising coil fixed condensation problems. It's little counterintuitive because on all other tanks pushing coil lower means better flavor, but here it's the opposite. Yesterday evening I watched some videos where people install 24gauge 7 wraps coils and they install it above screws. It means more...
  6. excalibur-x

    Spica RTA by Sirius Mods (mtl)

    What kind of leaking are you fighting with? I have no leaking problem, but there seems to be a lot of condensation in the base and sometimes also in the main air channel. I close JFC and give her a good blow to clean air paths and that's it. I still didn't completely master this tank but I...
  7. excalibur-x

    iJoy 40A 4200mAh 26650 Bench Test Results...overrated but a great 30A battery!

    Did you install service pack? What are your settings, what kind of tank are using, what is your cut-off limit? I get whole day of vaping 10-15 ml on 35W (50W preheat) without any warnings. Sent from my LeTv 1 Pro using Tapatalk
  8. excalibur-x

    High end RTAs

    I think designers of Spica had Skyline and GT3 on the desk when they were developing this tank. I don't have the Skyline but I watched lots of videos and I can say air inlet of Spica is similar. Main difference is that wall of the chamber is a part of the deck instead of the bottom cup...
  9. excalibur-x

    About to start my first diy liquid

    There are countless advice topics here and all over internet. I know it can be overwhelming. Couple of months ago I was in same position. I made a plan but I needed someone to confirm my plan is OK. Is my DIY plan feasible ? Now I have some juices I make in big batches and I use them daily...
  10. excalibur-x

    High end RTAs

    Spica is the brightest light in the constellation Virgo the Maiden. In my native Slavic language stars and virgins are female. In English I should use "it", but I feel more relaxed talking about giving HER a nice warm bath and a scrub instead of HIM or IT. :D
  11. excalibur-x

    High end RTAs

    After more than 1 month of waiting I received discount code for Byvape, and now finally Spica RTA is in my hands. I gave her a warm bath and a scrub before I coiled her with a spaced coil (0.75ohm) 3mm ID 28gauge SS316L. Prior to coiling I removed the 2mm restrictor because I want to see how...
  12. excalibur-x

    High end RTAs

    I thought you were replacing different o'rings. Eden mods offer small o'rings for the positive pin. Maybe last try. :D I love this atomizer. Yes, it can be a PITA with leaking, turning upper ring and high maintenance, but the way it vapes and how I got it, makes it my precious. I'm 986th in...
  13. excalibur-x

    Lost Vape Therion 166 (DNA250)

    I changed material to SS304 on mod directly and now on 220C it vapes as I would expect from this build. Maybe even little warmer, but this can be because when I rebuild last time I put the coil little higher than usual. I choose 28g because it's thinner and it uses less energy. I like twisted...
  14. excalibur-x

    Lost Vape Therion 166 (DNA250)

    Uuuu, so sorry. Typing error. I have to go to 240-250C to get warm and satisfying vape.
  15. excalibur-x

    High end RTAs

    O'ring here will fix leaking 510 pin. When I got this tank it leaked only after 1 tank. Luckily I unmounted the tank when I was refiling or I could damaged my mod. It needed just a wipe and it was OK. After that I installed 1 o'ring and monitored what is happening with the pin. It was still...
  16. excalibur-x

    Lost Vape Therion 166 (DNA250)

    I don't know where to ask, but do you have any experience with GeekVape SS316L and DNA? I have UD SS316L 26g and it vapes great at 220C. Doesn't matter id I build simple or twisted wire coil. Temp. of vape is same, difference is only with taste that is fuller with twisted wire. I bought...
  17. excalibur-x

    HCIGAR VT75

    After couple of days seems mod has settled nicely. After leaving tank on a mod for some time resistance settled at almost same level as on Therion and now vape is same on both mods. Green light indicates that charging over night finished at some point. In the morning it shows battery is at 96...
  18. excalibur-x

    HCIGAR VT75

    Mod resistance value I found in this topic. I don't have the tool to measure it myself and making a big short sounds bad so I have to use measurements from other users. Now when tank cooled down and mod settled difference is very small (0.01ohm) but I notice it when I vape using same...
  19. excalibur-x

    HCIGAR VT75

    I'm a new user of HCigar VT75. After some tweeking in Escribe VT75 acts same as my Therion 166 which is the the reason I again bought DNA mod. But I still have some minor problems: - IJoy 4200mAh battery wont charge to 100% (using downloaded CSV) -while charging no info about charging current...
  20. excalibur-x

    High end RTAs

    I had same problem but I fixed it with 2 o'rings that I stashed at the lower end of positive pin. Now no more leaking. But I still have problems with juice getting trapped inside positive pin. After cleaning and rebuilding it's not a problem, but after few days or if deck gets flooded too much...
Top Bottom
Forums
Products
Vaping.com
Star Suppliers
Blogs
Menu