Search results

Here is a picture of the voltage regulator with all the additional components. and here is everything crammed inside the wooden enclosure. To keep things in place, and tidy them up a bit, I used hot glue to keep all but the feed wires in the hole. The screws you see hold things...

I started this mod pretty much on a whim, with no real plan in place and using a 'scrap' piece of Mahogany. Much of what I ended up doing was to make things work. The piece of wood I had was about 1.5 inches by .75 inches I cut off enough to hold two Trustfire 14500 batteries end to end - plus...

In my mods I've always had lots of problems with switches. To get a switch small enough I would usually have to run the switch far past what it was rated for. This would burn the switches out pretty quickly and lead to complete failure, or at least 'flaky' operation. So far I've seen some...

Well, here is my 5V mod using a 7850 voltage regulator from Radio Shack. I wouldn't recommend using it, it get's very hot and shuts off after a vape - until things cool down a bit. While I wait for my TI PTR08100WVD as recommended in other posts, I added on a heat sink. OK, it might be a bit...

I am new, and can not post this anywhere other than here - I realize this should be placed under 'mods' I had a bunch of transformers that I do not know what they belong to, and found one that had a nice and convenient 5.1V .7A output. I normally use momentary switches for most of my mods...