My Smok AL85 is still going good. Bought it March of ‘18. The only mod I ever had die was a Fuchai 213 that I’d bought used. I’d say it had an underlying problem when I bought it though.
I got mine a few days ago. Loving the heck out of it so far. Have yet to use it out of squonk mode for more than a few moments. Can’t say enough good about it, though.
It’s possible. When I use single coil in my DR I use 3.0mm and 1/4 of a muji pad for cotton. No thinning. Fluff ends with your finger and cut just below deck. Did you find a suitable solution?
When filling your tank try these steps...
Close airflow
Fill and close the top cap
Turn the tank upside down
Hold for 3-5 seconds, then open the air flow
Turn the tank back up and use normally
I was told to do this (on Reddit) when I started and it’s worked for me on sub-ohm and rta tanks.
Which Nova mods do not have the ridges on the resin door plate? Is there a way to get a Silver/Colbalt without the ridges or is Onyx the only smoothed plate one that has the Silver trim? Thanks.
Been using this same method, basically. 1/4 of the muji pad, remove skins, no fluffing/thinning, tails 1/2 way between bottom of holes & bottom. Have had no problems yet.
I received mine yesterday. I was looking for something small to go on my Battlestar Mini when I go out. Love the flavor. Love the looks. Easy to wick & build.
I got a Serpent Elevate the other day and I have to say that their coily tool rip-off is quite handy. I’ve always used the handle on my Coil jig to measure off ‘drop in’ coils but I find this to be easier. I probably would have never bought the Coily anyway but I certainly can’t justify dropping...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.