more 32g kanthal A 200ft on ebay 8 left
http://www.ebay.com/itm/Resistance-heating-wire-Kanthal-A-32-awg-200-ft-/261057302999?pt=LH_DefaultDomain_0&hash=item3cc83a51d7
yes yes yes ye... ah man
i was so happy to get my ody i tore in that bag with that sparkle in my eye like on christmas when i was a kid
but alas i only recived the ody a bag of wick and one bag of wire not sure if its r/wire or nr/wire
with all the rush to get orders out some my be missing...
Sorry to post this here but my dang charger died today and need to get a new one and i know the family will help me getting the best 3.0-3.7 charger out there insted of wasting my money on a sub-par charger.Like my old one thanks for the help
I think a horizontal dial with 3.5-8 v with .5 v increnmental marks sort of like adjustable drawtank and nut. I think this would make for a look we already love and would make for a stealth vv addon as far as looks go i would like to here your thoughts
hay imeo have u thought of using Tungston to make GG. The only reason i ask is i was looking at wedding rings and they looked verry nice. but i dont know about the ohm rating of Tungston. but some of the rings were in black not painted i think it was heat treated or somthing. but a black ggts is...
As for me I hate everbody using a UFS right now. You might ask why would a member of the family hate me.
The only reason is that someone like you and I lucky enough to get his pre order UFS and have sent by Bruce's loving staff or by the man himself and then have THE G**D DAM USPS LOOSE YOUR...
Imeo i did the bevel tip last night and using it now and works like a charm. i havent got any juice in my mouth like the flat tip did and no more juice than if u were using the 901 i cut it with a beveled bit and polished the hell out of it i think u would like the two tone look of the nickel...
Imeo i dont know if i am the only one who gets juice collecting between the 510 connector tip and mouthpice but it happens to quite often and its probaly my fault not getting the correct air/fluid mix.
My thought is to put a small bevel on the 510 tip so the juice has some where to flow back...
line up the holes of atty with groves of conector ,to get this to happen i have to screw atty down hard what i mean by hard is finger tight + 1/8-1/4 inch turn to line up breather holes with conector groves
hope i didnt screw up bats when tested 1 got below safe discharg level of 2.5v to 1.1 the other one was still @ 3v i hope this isn't a sign of the new year
well i was getting 8-9 hr off 4.5ohm 901 vk @6.4 v but i knew that was going to go down with the 3ohm 510 when i first got 510 adp was getting 5-7hr all last week @6.4 v 2x500mah aw lipo4 and all was good then tuesday gg got warm and bat life went down 1 set @ first now both sets drain fast...
ok the trouble is a short that much i know. I have changed the atty 3ohm 510 vk and checked .... spring and all the normal things that cause a short. My question is how tight do we tighten the atty and will that cause a short if its to tight or to lose?
I am tired of a warm GGTS and going...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.