Search results

Is this a single coil mouth to lung ya think?

My IPV D2 is also SX130H V2.0 The up button does not wake up the device.

My up button does nothing if the screen is dark when I push it no matter how long I hold it down. The fire button and down button will wake it but not the up on mine.

Ok I got a D2 tonight and I have what might be a silly question. So when my screen is off and I hit the up button it does nothing. After I wake the screen either by touching the fire button or the down button the up button works perfectly. Is that the way this is designed or is it a flaw in my unit?

I Put in a fresh battery at around 10 am today and I just a notch below half battery at 7:30 pm. I have been vaping at 75 wattts and 495 degrees most of the day a little on the power mode at about 50 watts on my Crown tank.

Ok I have been playing with this thing in Temp control for a couple days. I have a Crown tank and It came with a .15 dual nickel coil and two other dual coils that use stainless steel heating coils a .5 and a .25. The nickel coil seems to get too hot or dry out anyway I seem to get a dry hit on...

i just tried a few different atties on mine and reads exactly the same as my ohm reader.

Sometimes on mine if your not paying attention the doors don't snap down exactly perfect you just give it a little squeeze and everything lines up perfect and tight.

I like the double doors really is easier to change batteries. On mine once you get the doors on there good you cant really tell they are doors.

Wait you mean they come with a manual??? LOL

Well I got my 75 watt today. Really impressed with the build quality. No button rattles nor door movement which is really impressive with dual removable doors. I noticed the little gap under the atty on mine isn't caused by hitting the doors as some have said but its due to the actual connector...

Yeah i just got mine too and I ordered mine at 3 am eastern time this morning.

Anyone find out if this can use Ti wire or is it Ni200 only?

You know it really ticks me off when I set my T6 at 100 watts take a few hits and then take my atty and put it on a mec and it hits much harder!

Well these are not clone devices these are devices that were designed and created by Cloupor. Their number one selling point was that these were to be able to reach a wattage of 150 watts T8 or 100 watts T6. They touted it everywhere they could. Needless to say I do feel kind of ripped off. Had...

I don't have the T8 but I got the T6 and it doesn't seem to be putting out to its advertised specs either. So to me its like paying for a Corvette and getting the performance of a Malibu. Would you say well the Malibu performance gets me from point A to point B so I guess I can live with it?

Anyone done any further testing? My brother has a Fluke true rms meter I just haven gotten over there to test with it. I may do that tomorrow though.

Nope not yet. Really it looks as though they plan to just sweep it under the rug and call it a day. They have taken the T5 completely off their website.

The mod shuts down when the board reaches 60 degrees Celsius which is 140 degrees Fahrenheit .

Every time I got to Jwraps site I don't see the T6 listed?? Edit: Never mind I just looked again and its there now. lol