No more of R J Reynolds for me i just tested one of my vuse wicks also and when i put it under a lighter it turned in to melted peace of plastic :facepalm:
Anyone else having problems with firmware 20140813 v 2.4 where it keeps going into lock mode and it won't fire or is it just me.I had 20140808 v2.3 installed and had no problems with that version might have to downgrade.
It cost around $100.00 for the enclosure and shipping.I was going to use another baps lid's but, then i seen the Aries on shapeways and loved the curvy look.I like the curves a lot better than a plain square box.
I moved the ground wires for reverse battery protection for both of my sx350 and my resistance reads fine where did you heard this from and do you have any links:)
The chip isn't in a mod yet it's here on my table i guess i'll do a reflash tomorrow and see if that does anything.Thanks for the help kevinn and hope your atty is ok.
The notes did state the limitations are starting at 1.2Ω for 51-60w and like you said it might be for safety reasons.I did the update also and now i'm getting .2Ω to high are you resistance readings off any i don't know if it's a loose connection or what.
When i check this site below it shows nothing for evolv vw. I think it's just a application and has not been granted just like notcigs vv.
Search for Patents
http://www.patentlens.net/daisy/RiceGenome/3543.html
Check this sx350 varitube thread for help.I had the same problems on my sx350 box mod from bad battery contacts and using to thin of wire.
http://www.e-cigarette-forum.com/forum/e-cigarette-suppliers-forum/559302-yihi-sx350-35w-chip-varitube.html
I'm glad the 60w files work with the wattage buttons or i would have not done the upgrade on a side note here is the upgrade warning before you flash the chip.
16 gauge teflon wire is about the same diameter as 20 gauge silicone wire with the teflon having thinner insulation and a lot stiffer.Here is my sx350 with some 16 gauge teflon wire.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.