Search results

Looks nice and like the innovation. Thanks for the new contest.

Currently for me, as of today, I find that my favorite e-liquids taste best in certain atomizers using certain styles of vaping TC or wattage mode. So many variables (too many actually) such as wire types, wire gauges, resistances, wicks etc etc. But here is a list of atomizers that I'm...

I'm very careful with my snips, especially since we have two cats and a dog. Don't want those snips to embed into their paws and/or our feet if the wire falls on the floor. I usually snip into a sink and rinse the snipped wire down the drain. I found if I point the wire that is going to be...

I remember when the horizontal hold or the vertical hold would mess up my father would give the TV a calibrated tap on it's top or it's side to fix the problem.

Amen! lol

Here's how the KFM3 in the Red Sky Destroyer DNA 20 Mod looks. I haven't used this mod in years since it will not accept any tank greater than 20mm dia. I'm enjoying this combo a lot.

Empty

I've been vaping the KF mini V3 now for a little over a week and I'm really enjoying this little RTA. The best part is I have it in a old Red Sky Destroyer DNA 20 mod which I haven't used for years because it wouldn't accept any RTA's greater than 20mm in diameter. It's as if they were made for...

Good luck everyone. Just saw a positive review by PBusardo. Nice device.

Just watched PBusardo downloading new update for SX min M class (V2.1 firmware). I'm going to wait till he reports back on how it works.

VariTube has them in stock.

RMS and DC are equivalent. RMS (root - mean - square) is arrived at by taking the square of an alternating signal, then taking the mean value of that squared value and then taking the square root of that mean value, thus arriving at a equivalent DC value of the original AC (alternating voltage...

Mine does that also.

It sounds like it may be a intermittent short. The coil going beyond the build deck may have something to do with it IDK. I'm hoping when the 30 and 28 ga NI200 you ordered, when it comes in, and you build a coil with 30 or 28 ga the problem will go away since you'll need a lot less wraps so the...

JJ, sorry to hear your still having trouble. Without seeing the build it's hard to tell what is wrong. You may want to try a build on a different atty or try wrapping a different diameter coil. Then again, maybe the different gauge wire you ordered will fix the problem.

Buzz, I get a rash with metal with nickel in it as well, but so far (vaping 3 days with NI200) no side effects. Ordered some Ti as well just incase. I'll post if anything changes.

Just incase the OCD gets the best of you (lol), last I looked VariTube has the Grey/silver and the Rose/silver in stock. The Grey body part is more like gunmetal. Also they now have the extension tube for 120W vaping with Kanthal.

Tony, I think you meant .07 ohms. I think .07 ohms is to low, especially since the lowest ohms is .08 ohms that the mini m can handle according to the spec sheet. He's at the "hairy" edge at .07 ohms.

I'm really liking this TC using a dripper. As soon as the vapor diminishes I add more eliquid. No more burnt cotton or overfilling the atty. This is my first TC unit, never tried the DNA 40.

On my NI200 coil I first checked the resistance on a ohm meter it read 0.18 ohms. Then when I put it on the SX mini m it read 0.17 ohms, so far the two ohm readings have been close. When I make another build, (probably using the Kanger Sub Tank mini) I'll see again how the two ohm reading compare.