Search results

Thanks to Mamu and others for all the help! My Milo is finally done! Wiring is still a bit messy but I was able to do a square cutout for the micro usb at least. Some words of advice for noobs such as myself: 1) Measure twice and cut once (especially for the door) 2) The battery wires are...

Hi Mamu, thanks for the reply! It is really weird, sometimes I see the messages and sometimes I do not, but it usually occurs when I wake the device up and not when I am actively vaping. I will check out the contacts though so thanks for that tip. Do you have any idea of why it might happen...

The battery holder is from fasttech https://www.fasttech.com/p/1258801. Milo Sr. is finished, although the door is not fitting 100%. I cracked one door since the hole is so close to the edge, does anybody have any recommendations to alleviate this issue? Here he is . I do not know how you...

Thanks again for all the help guys, I was able to get my Milo Sr. working as intended , I know the wires are a mess but I didn't realize until after I heat-shrunk that they were a bit too long =]. In terms of the plexi door though, what would be the best way to cut it? I have access to a...

I performed the surgery on both of my DNA boards and it appeared to go well. Thanks again Mamu, you are a wealth of knowledge! I am building a Milo and a Milo Sr. (In a 1590B enclosure), all that is left is epoxying the buttons and making sure all the connections work before I shove it all in...

Thank you for the response retird, I will use my mouser switches instead. Mamu, in your PDF you state that when using a tinted cover, one must remove the black transparent piece covering the OLED. If I am interpreting that correctly, I am going to have to physically separate the two plastic...

Thank you for the advice Mamu, the DNA powered on =]. Although I purchased the buttons listed in the PDF, would it be ok to use these switches as well? 3 x Momentary Push Button Switch DC 50V 0 5A Black Knob USA Seller Free SHIP | eBay . Thanks again for all the help!

Hi there guys, I am trying to build a MILO but with dual 18650s running in parallel instead. I have everything connected and I just wanted to verify that all my connections are working, however when I attempt to power the unit on the screen remains non-responsive. I also tried with the USB...

count me in and thanks!

Congrats on the Vapaversary!

count me in!!

count me in! thanks for the contest

#3 Wicked Watermelon thank you. and good luck everyone!

#2 Juicy Fruit Gum

#1 Spearmint

i still want in!

i took out the seal reset it gave it a squeeze and nothing, then i tired without the seal squeezed the bottle as hard as i can and still nothing :( thanks for your input though ;)

helpppp my vmodxl doesn't feed :( i squeeze and squeeze but there is no give, it feels like the bottle will pop :mad:

hi dweed and congrats!

2 minis, 2 extensions and 4 batteries pleaseeee :D