Search results

So all of a sudden i seen this glow, fire it a few more times and watched it ark from batt to switch. That's prolly not a good thing haha so got a caravella clone on order. :) Vape Safe my friends!

So sitting here at work...vape starts behaving oddly till i unscrew the tank to see it starting to flood. SIGH...oh well .... happens i suppose, just blew it out and adjusted the cotton a bit till I can get home and re-wick it. Me little rant since I'm alone at work and got nobody to chat to :)...

Hey fellow canadian peeps, been a long while since i've been around but got a nice set of clones running. A nemesis and a prometheus dual coiled @ 1 ohm with cotton. Hits well with the magnet switch. Cheers.

So I have a killer 705 clone that I can't setup due to the ceramic cup being too snug to the centre post. 1st attempt of just using a file wasn't so successful, so before I go and see what else I can do to widen it out by just a mm or so. Any advice on what you guys or gals have done with said...

Been awhile since I've posted anything but since I've discovered the "micro coil" I have to say it's an awesome expierence as the coil came out @ 2.6ohms using 9 wraps of 32g kanthal so run it at 5v for 9.6ohms and will probobly stick to this style for awhile. Cheers.

All resolved

So just a quick question as I've only worked with kanthal, Does anyone notice a difference with nichrome as far as taste is concerned?

So made my first sub ohm genesis this evening. Used twisted 32g kanthal and at 1st it metered out at 1.2ohms used for a few and wanted to see if my lambo 4 would read it and came out at .8/.9 so i was like hmm set it to 3v and it fired but I'm using it on my mech.

Just like to make a quick shout out to the ecf board that it's been a great 1st year being smoke free. I have learnt sooo much from the great community here. Thanks to all for the support and info thats' been shared here. Vape on and Vape hard!

At the bus stop and was getting a lot of mystery gurgle seen some juice down the centre tube and of course thinking in my head ... is going on. So to avoid a pocket full of juice I decided to dump it out, sadly but at least it was only about 1ml.

So now that I've acquired enough devices to make comparisons its quite noticeable that I have to bump up my lambo4 to 4.3/4.4V's to where my LT1.5 runs at 4.0V's on the same 2.1ohm coil to have the same effect. My only gripe about the new lambo is that the air channels on the 510 are too small...

Just sharing my new LT with a 510/510 cause I don't like how the vivi nova groves the centre pin over time.

First impression was way smaller than anticipated which is nice, and the V's is exactly where I need it to be. Ohm checker is a nice feature too :)

Whats the best method of trying to reshape a carto after the tap valve with its punch depressions warp it to the point where its almost not gonna fit back into the tank, Unless that is something to be said for using crome caps with no give? P.s makes me wanna buy a dremel....

This morning I placed an order for the nice looking Gold EVO with of course some aw imr 16340's (4 just to have extra), charger, a dct v2 tank with an extra ss drip tip (just cause i wanted to make only 1 order). All for just under $110 with shipping/tax/cod. Now I wait....

So after now vaping for about 2 months ( and yes i lurked on here for info in the beginning ) I felt its definitely time to register on the forums. My 1st vape was on an ego-c kit; was definitely fine in terms of use but hated the whistle tips and how fast the condensation built up. Having said...