1.6 ohm bvc coils on mech mod?

[Bgibbons123]

I have been using the 1.6 ohm aspire bvc coils in my mini nautilus on a kangertech vv twist and have been vaping at 4 to 4.2 volts. I really like the look of the brass mechanical mods and was wondering if I would be able to get away with using my mini nautilus on one of them?

 

[Sgt.Rock]

I test ran one of my 1.8 ohm BVC coiled Nova-S's on my mech for a while and it worked just fine...I can't imagine a 1.6 would do any worse..in fact it oughta rock.

 

[Flt Simulation]

a 1.6 ohm coil being fed 4.0v = 10 watts

That's what I use in both my Kayfun Lite RBA and Kanger Aerotank Mega clearomizer.

Nice vape!

 

[gin828]

I run my full size nautilus on my Z2.2 18650 and it does pretty good. Just remember to check your battery with a meter so you don't run your battery to low. It take a little time but you will able tell when to change batteries out.

 

[eyerhere]

If you like the way it vapes at3.7 volts also a mech will be ok. If not you will want to get a kick or stick with vv.

 

[Ryedan]

If you like the way it vapes at3.7 volts also a mech will be ok. If not you will want to get a kick or stick with vv.

This ^^^. Batteries do not stay at or over 4v for long. They spend most of their time between 3.8-3.6v.

 

[Bgibbons123]

I've been considering the kick how much space do they take up I would prefer to have a shorter mod if possible. And how reliable are they?

 

[gin828]

It all depends on your mech size and what battery you have. My Z2.2 tube is for 18650 battery so i can not adjust length but i can still run a KickII by using an 18490 battery plus the kickII. The 18490+kick=18650. The 18500 battery doesnt fit well with my mech because the 18500 is a little longer. i can also use an 18350+kick=18490, I just have to get an 18490 tube. It all depends on your mech.

I have been using my KickII by Evolv for about a month and its been flawless. I run between 8-12watts depending on juice and atty combo. Its has been consistant vape and I clean the contacts once a week. Just remember there is NO reverse battery protection so if you put your battery in backwards it will fry the board

A PBusardo Review -The Kick 2 - YouTube