- Status
I have so far used my Mini exclusively with Dual Coils, I use it as my day-vape device with a standard length DC Tank at 4.6V and I generally need to change battery around mid-day/early afternoon (Umm about 2ml->2.5ml of juice used).
While it certainly lasts less time than a 18490, its not a huge difference and the convenience of the size makes it a great pocket and go device for a day in the office (I always have a healthy supply of spare batteries/juice at work/in car just in case).
While it certainly lasts less time than a 18490, its not a huge difference and the convenience of the size makes it a great pocket and go device for a day in the office (I always have a healthy supply of spare batteries/juice at work/in car just in case).
I've been getting 6-8 hours out of the 18350's w/ 3ohm DCT's and SCT's running at 5.7-6volts.
ProV are u getting a pretty big hit with that setup?I have been using 3.0 ohm DCT for awhile now but at 7.4v in some mods I have and tried them at 6v and not powerful enough hit for me.Mainly use tobacco flavors and even at that high of a voltage flavor still good.
Been on the fence about getting the mini but just got a BP and it only goes to 5.6v and not strong enough for me with the 3.0's.Do u think the mini would still fire with 2.5ohm DCT AT 6V?
Been on the fence about getting the mini but just got a BP and it only goes to 5.6v and not strong enough for me with the 3.0's.Do u think the mini would still fire with 2.5ohm DCT AT 6V?
Yes, it hits very well and provides the throat hit I was used to with cigs. I'm mainly using Blueberry Tobacco and Vanilla Cigar (TW Patriot Range)
I'm not sure about a 2.5ohm DCT @ 6v as I've only used 1.5 & 3ohm. I had to run the 1.5ohm DCT at 3.1 volts to prevent burning flavor. The mini wouldn't fire the 1.5DCT if the voltage was above 4. I found the vapor production with the 1.5DCT to be underwhelming.
The 3ohm DCT's (and SCT's) and the provari mini are an excellent combination IMO.
Absolutely, I haven't actually tried (I use 1.5ohms). However 6 V at 2.5 Ohm draws 2.4 Amps, The Mini will do up to 3.5 Amps, so will handle 6V 2.5ohms quite happily.
Thanks for replies,thought it would at 2.5ohm dct at 6v....probably would use the 2.0ohm one's at 6v with that much amperage left.ProV your saying with the 1.5ohm DC at 4v your mini wouldn't fire?Did u check the resistence on your carto?Think others have told me they could get them to fire up to 5v.
I was able to fire a 1.5 ohm DC carto up to 4.8 volts without seeing an error.. That was more than enough vapor and TH for me. Don't know who said they couldn't fire past 4 but that sounds like a v1 provari to me.
Sent from my SPH-D710 using Tapatalk
Sent from my SPH-D710 using Tapatalk
- Status
