1st rda or rta

Status
Not open for further replies.

bholcomb22

Super Member
Verified Member
May 13, 2014
420
304
Denver, CO
If you want a strong throat hit I'm assuming that you like a tighter draw. I only a achieve a good throat hit from a mouth to lung inhale. In that case I would recommend a RTA over an RDA....

The only RTA I know of right now that has a 3 post design is the orchid, but that is going to be a device that is more geared towards lung inhales from what I have heard.

My two recomendations would be either the Eleaf Lemo or an eh pro kayfun lite v2. Both extremely good attys and they are very very VERY similar. The lemo has adjustable airflow, and when it is toned down has massive throat hit. It actually does have holes you can stick your leads through on the bottom of the deck, but they are kind of in a weird place. (I never use them)

The eh pro kayfun clone does not have post holes, but I can't stress how easy it is to trap the leads under the screws. It is especially easy because you don't suspend the coil while doing it. Your coil can be on the build deck while you are trapping the leads, then you just pull it up a couple of mm. Super easy.

Can't go wrong with either one.
 
I agree about the Kayfun. It's really not as hard as you'd think.

I also just got a new Magma RDA that's amazing. Fairly strong throat hit - especially if you cut the airflow down, ungodly amounts of flavor and probably the easiest build I've ever done. I got the Tobeco version from a local shop, but I had to go through 5 of them to find one that didn't have spinning posts and airflow that lines up properly. I'd suggest you get the Infinite version if you can't get it from a B&M.
 

Neil7289

Full Member
Aug 1, 2014
33
1
England

Thank you for your help, I do like a tighter draw so I'll look into them. The reason I didn't want the screws is because I had a kayfun lite plus clone and the screws were so small it took ages to get the wire trapped under them.

At the moment I have a tesla which can only go up to 15w, would I need to buy a new mod to use with these?
 

bholcomb22

Super Member
Verified Member
May 13, 2014
420
304
Denver, CO
Thank you for your help, I do like a tighter draw so I'll look into them. The reason I didn't want the screws is because I had a kayfun lite plus clone and the screws were so small it took ages to get the wire trapped under them.

At the moment I have a tesla which can only go up to 15w, would I need to buy a new mod to use with these?

I had a a tobeco kayfun clone and the screws were a PITA to trap leads.... My ehpro is super easy. Takes no effort.
 
Status
Not open for further replies.

Users who are viewing this thread