306 Atomizers in Ody

[jslick_007]

Anyone know if this is possible? I want to use the stash of 306 atomizers that I have as a backup for my rebuildable Ody when I travel. I figure I need the following 510 parts to make it work:

• Odysseus Atomizer Insert - 510/CE2 Mode
• Odysseus Atomizer Insert Center Pin - 510/CE2 Mode
• Odysseus Atomizer Insert Insulator - 510/CE2 Mode
• Mouthpiece Cone 510 Mode
• Mouthpiece Cone Nut - 510 Mode

I already have the tank sections for full mode (minus the full mode mouthpiece), but I wasn't sure if the 510 Mouthpiece would create enough of a seal on the 306 to prevent flooding.

PS - Still looking for full mode mouthpiece if anyone wants to help a fellow GG brother out.

 

[lianad]

306 to 510 Drip Tip Adapter - Drip Tips - Cartridges

 

[Killjoy1]

I've used those adapters for a 306 in my UFS, haven't tried it in Ody, yet

EDIT: here's a US vendor that has those adapters 306 to 510 Drip Tip Adapter - Avid Vaper

 

[jslick_007]

So the idea is to screw the 306 into the Ody Atomizer interface, put one of these on top the 306, and then screw on the Odysseus mouthpiece is that correct?

 

[Killjoy1]

Yep. The adapter is a little bigger around on the upper half than a 510 atty tube, so I don't know how well it will fit in the Ody mouthpiece

 

[jslick_007]

Yep. The adapter is a little bigger around on the upper half than a 510 atty tube, so I don't know how well it will fit in the Ody mouthpiece

That's actually my biggest concern is creating a good seal around the atty under the mouthpiece, but I guess I'm venturing into unknown territory as no one can confirm.

 

[OctobersRust81]

i cut down an extended 306 drip tip in a tube cutter and used the bottom of it and it works fine with no leaking. the bottom piece is 1.5 cm.

 

[Killjoy1]

Lol, why didn't I think of that? Nice work-around, mate! I'm gonna have to give that a try

 

[jslick_007]

i cut down an extended 306 drip tip in a tube cutter and used the bottom of it and it works fine with no leaking. the bottom piece is 1.5 cm.

Nice... Thanks... Couldn't believe I was the only one with this idea, but I have a drawer full of 306's I figured I could put to use in a pinch.

 

[Mosin_Sergei]

Perfect solution for using OctobersRust81

i cut down an extended 306 drip tip in a tube cutter and used the bottom of it and it works fine with no leaking. the bottom piece is 1.5 cm.