I am still uncertain where to post stuff like this. The main DIY e-pipe thread seems to be a single thread in the model-specific forum with a zillion replies. To me that just makes it impossible to browse the subject. I also looked to post to another related thread I started, but the topic is closed. So here is a new thread here.
Since 3D printers are now fairly common, and some are even at the $200 price point, I think this is technology going to explode into the world of e-cigs. But, 3D models of e-pipes seem to be farrly rare. But, more are starting to show up. Part of the challenge is finding the right search terms. The word "pipe" tends to bring up pipe fittings. Many don't use the phrase "tobacco pipe", so searching is very difficult. Here are a few on Thingiverse.
This just the stem;
Extended Tobacco Pipe Stem by earthtown - Thingiverse
This is a page of models by "Mastercaster" It includes pipes and e-cig related models.
About mastercaster - Thingiverse
Note this e-pipe model has provisions for all the internal parts, which he details.
Simpler E-pipe by mastercaster - Thingiverse
-Joe
Since 3D printers are now fairly common, and some are even at the $200 price point, I think this is technology going to explode into the world of e-cigs. But, 3D models of e-pipes seem to be farrly rare. But, more are starting to show up. Part of the challenge is finding the right search terms. The word "pipe" tends to bring up pipe fittings. Many don't use the phrase "tobacco pipe", so searching is very difficult. Here are a few on Thingiverse.
This just the stem;
Extended Tobacco Pipe Stem by earthtown - Thingiverse
This is a page of models by "Mastercaster" It includes pipes and e-cig related models.
About mastercaster - Thingiverse
Note this e-pipe model has provisions for all the internal parts, which he details.
Simpler E-pipe by mastercaster - Thingiverse
-Joe
