5v WoW Mod + DCT Tank Issue...

Status
Not open for further replies.

VaporPhreak

Super Member
ECF Veteran
Verified Member
Jun 30, 2009
656
66
Indianapolis, IN
Ok so I have had the 5v WoW for a while and love it. I just purchased a DCT tank and got in today. I put it on and vaped until my nearly dead batteries gave up the ghost and needed charged. Replaced the batteries (2x 16340) and when i hit the button the light came on but no vape and the light wouldnt go out. I pulled the batteries and tried again light flashed, no vape, and nothing after. Pulled the batts and tried a few more times and it randomly does one of the above two symptom sets. Pulled the tank off and put on a Boge carto, works fine. SO... Any tips on getting these things to work with tanks? BTW tried the tank with both 1.5ohm dual coil and 2ohm dual coil, same thing with both.
 

VaporPhreak

Super Member
ECF Veteran
Verified Member
Jun 30, 2009
656
66
Indianapolis, IN
UPDATE: Ok so I used the Boge carto for about 15 minutes then switched back over to the tank and now its working fine. So it must just be when the batteries are fresh that it hates dual coils... odd.... going to pick up some cr123a batts and see if it does it on those when they are fresh. I dont think it will since they are only 3v batts.
 
Status
Not open for further replies.

Users who are viewing this thread