70VG vs 80VG

[Shai Austin]

What is the difference in vapor production between the two?

 

[AzPlumber]

8.75%

 

[Asbestos4004]

None, unless dripped on to a coil. In that case, I'd agree with the plumber from out west.

 

[Northernshrink]

8.75%

Are you sure and if so what method of measurement are you using

 

[Shai Austin]

Well yeah it would be dripped on to a coil, using TFV12 Prince with a Prince-T10 .12 Ohm Decuple Coil

 

[Letitia]

At the watts you're probably using not much difference, clouds will be a bit creamier. Max vg will give you the best cloud.

 

[the wind]

Are you sure and if so what method of measurement are you using

good point.What is the Percent Change from 80 to 70?

 

[Nick L]

12.5% less.... Do I win a prize?

 

[AzPlumber]

good point.What is the Percent Change from 80 to 70?

Ya but, there is a 3.75% reduction in vapor from 12.5% due to 33.33% less PG


eta: Real answer is about 14.285714285%

 

[Topwater Elvis]

What is the difference in vapor production between the two?

A 10% difference in Vg ratio may or may not make a noticeable clowdz difference.

You'll have to figure out a way to quantify bro cloudz then try it for yourself.
There are far too many variables & delivery device set up details to even guess how much.

 

[QcVaper]

I use alot of 75 and 80%VG juices and there's absolutely 0 difference in my drippers
Oh and reading the comments, @Shai Austin NO you cannot drip on a smoke prince tank, it's not a dripper it's a sub 0hm tank, dripping on it will only serve to flood the coils in your case.

 

[stols001]

Well, theoretically it should give you a bit more vapor production. More VG usually means more visible clouds. Whether you will notice/like the difference is going to be hard to tell, as tons of other variables tend to come into play, like wattage, flavor, build and etc. But generally, if you increase VG you will decrease throat hit (possibly flavor) and increase cloudiness.

Sometimes, it can be harder to get wicking to keep up but if you are using a sub0hm tank, I wouldn't expect to see a HUGE difference in wicking, 70 VG is fairly high already.

Anna

 

[suprtrkr]

Hi and welcome. Probably not a huge difference in practice.

 

[NealBJr]

What is the difference in vapor production between the two?

That's like asking if 13 ounces of beer will get you drunker than 12 ounces of beer. Theoretically, it will, but depends on if the beer has the same alchohol content , how fast you drink, etc...

Vaping has so many variables to consider. There is airflow direction, quantity of air, coil ohms, wire type and wire size, juice supply, juice type, chamber size, how you inhale coil preheat, driptip type, and many more. On a generalized way of thinking, PG has the consistency of water, and tends to hold flavor a bit better in general than VG. VG has the consistency of vegetable oil, is thicker, doesn't wick as easily, but has a smoother taste and generally produces more clouds. The trick is, since VG doesn't wick as easily as PG, there is the chance you can get more clouds with some PG instead of a straight VG blend... it all depends on the setup.

So, the difference between %70 and %80 is generally not much to worry about. If you're looking for more clouds or more flavors,you'll get a much higher change switching atomizers, wicking methods/styles, or switching wattage.

 

[Cas002]

The trick is, since VG doesn't wick as easily as PG, there is the chance you can get more clouds with some PG instead of a straight VG blend... it all depends on the setup.

That's a really good point. My experience has shown that above the 70VG threshold the capillary action of the organic cotton is measurably impacted, and with cold weather (outdoor vaping below 30 degrees), dry hits occur faster after several consecutive pulls. The cold air quickly cools the small amount of juice increasing viscosity and affecting the capillary action. At 50/50 or even 60/40 VG I haven't experienced the outdoor dry hits in winter. Thus Neal's theory makes sense - if you want clouds, going too high on VG may have diminishing returns, depending on your setup.

 

[BrotherBob]

Well yeah it would be dripped on to a coil, using TFV12 Prince with a Prince-T10 .12 Ohm Decuple Coil

Welcome and glad you joined.
The information below may help you fill in some knowledge gaps (differences in PG vs VG ratios in a mix). Just a few have already been mentioned.
Might like to read:
http://www.vaporauthority.com/pages/learn
Vaping and Inhaling: Everything You Need To Know
https://spinfuel.com/new-vapers-start/
http://www.ecigarettedirect.co.uk/a...tte-college-guides-tutorials-information.html
http://guidetovaping.com/category/e-cig-beginner/
http://vapingcheap.com/vaping-101/
6 Quick & Useful Vaping Tips for Beginners
https://www.e-cigarette-forum.com/f...up-the-vaping-ladder-with-egos-and-mods.5058/
https://www.e-cigarette-forum.com/f...nk-or-what-a-guide-to-juice-attachments.3230/