801 attys

Status
Not open for further replies.

youngll11

Super Member
ECF Veteran
So I started a thread about my 801 problems, but figured I'd start a new one with my updates. I have 2 attys from ruyan. Atty 1 has been working great, but my second atty is extremely hard to draw on, even after blowing it out. It still produces a good amount of vapor, but it's just quite a hard draw. However, when I compare the two attys by sucking on them with no battery attached, there is almost no discernable difference. It is only after I attatch the generic 801 batt that the second atty becomes a PITA. Anyone know what is going on?

Also noticing a loss oftaste in all my devices, but the 801 especially...
 

breakfastchef

Moved On
Feb 12, 2009
2,225
8
I find the Ruyan 801s generally do draw harder than, say, a BE112. I think part of the problem has to do with the threads. If the atomizer fits the battery threads too well, it seems to impede airflow. When this happens, I remover the ring around the atomizer connector to allow more airflow through the air holes molded on the side of the connector.
 
Status
Not open for further replies.

Users who are viewing this thread