First post here on the forum. I have been through a lot of setups, but this is my mozt current... I have a nemesis clone, currently with an igo-w that I drilled out. I bought a fogger v4 (4.1). Built the coils (.30 ohms) with 24 gauge kanthal and organic cotton. My issue is that I can't get this thing to not taste like a fireball. coils are firing together and I'm sure it's a wicking issue. Is there a good video online that shows how to do this right? I dont have the cotton stuffed down all the way (only half way down the channel). Thanks for any help!
A question for everyone and also... hello!
- Thread starter zombies4lunch12
- Start date
- th_trl_thread_readers 0
- Status
Check out vids on YouTube. This is just one of many https://www.youtube.com/watch?v=5YYf8gMmRKU.
Show us a pick of your coil and wick. My guess is your cotton just can't wick fast enough at 0.3. If u pulled the wicks now.. Are they scorched? Could have too much cotton in there.
If you've got 28ga, try a dual coil 7 or 8 wrap... Should get you to 0.7-ish which is good for me.
The fogger is airy, but I don't think it's airy enough for 0.3 ohms. You'll find that most folks who go that low, do so on a dripper, with big air holes.
Edit: welcome to ECF bud.
If you've got 28ga, try a dual coil 7 or 8 wrap... Should get you to 0.7-ish which is good for me.
The fogger is airy, but I don't think it's airy enough for 0.3 ohms. You'll find that most folks who go that low, do so on a dripper, with big air holes.
Edit: welcome to ECF bud.
Last edited:
Is the difference between 24g and 28g huge? I tried this with 8 wraps initially, but I couldn't get the chimney back into place without the coils touching it due to how small the space is unfortunately.
Sounds like 28g is the standard... should I buy the straight or the twisted? I've seen videos of people using both, is it a preference thing or is one better than the other?
Like Hawking said there is a definite difference between 24 and 28 gauge.
With that thick of wire a .3 ohm coil seems like it would come out tasting funny try making the the change to 28 Gauge then aim for like .6 Ohms I had a build at .58 with my straight 28 Gauge Kanthol on a fogger and it was nearly perfect.
With that thick of wire a .3 ohm coil seems like it would come out tasting funny try making the the change to 28 Gauge then aim for like .6 Ohms I had a build at .58 with my straight 28 Gauge Kanthol on a fogger and it was nearly perfect.
Also Airflow may be a problem with the flavor since when you vape if there isn't enough air the flavor can come out tasting burnt.
There is a difference in twisted and straight twisted will have a higher resistance I believe I'm not 100% on that tho I know there is a difference tho
- Status
Similar threads
- Locked
