Ok, I never pay attention when I read something important. So I need a little help with this mod.
I want to take an old 510 atty tube and put a resistor or diode in it with the leads of it soldered to the center connector and the put a battery connector in the top and also solder the other lead to that center pin.
Basically making and adapter to lower the voltage. ie. to make a 2.3 ohm 510 atty run at 3.3 ohms or more. once I screw the atty to my new adapter.
I need some links or specs on what to get, I think I can only put 1 of these diodes or resistors in the adapter. I would like to even shorten the atty tube to make it as small as possible with out crushing said diode or resistor.
I want to take an old 510 atty tube and put a resistor or diode in it with the leads of it soldered to the center connector and the put a battery connector in the top and also solder the other lead to that center pin.
Basically making and adapter to lower the voltage. ie. to make a 2.3 ohm 510 atty run at 3.3 ohms or more. once I screw the atty to my new adapter.
I need some links or specs on what to get, I think I can only put 1 of these diodes or resistors in the adapter. I would like to even shorten the atty tube to make it as small as possible with out crushing said diode or resistor.