addy extra holes mod

[opyrus]

got addys you feel the pull is to stiff well you can make the air in takes wider or add 1 or more as you see fit. all you need is a small about 1 inch to no wide nail put it inside an existing hole an tap it with a hammer 2-3 times then check the draw. to add a hole hold the addy in place put the nail where you want the new hole a give it a few small taps with a hammer should now have a new hole. i personaly got some 1 hole addys the one hole was to small i made it wider and added a 2ed hole some other addys ive had with 2 holes but to small also simple fix.

 

[sanfordf]

Where on the atty do you put the holes? Near the existing ones by the threads on a 510? I don't think a nail will penetrate the brass without destroying the atomizer. A very fine drill might work. As long as you don't break the ceramic bowl or bust one of the leads to the coil.

 

[Switched]

I believe he is talking about an 901. I am not sure why anyone would want to suck more air in with their vapour, but hey whatever floats their boat.

Personally I have found that hitting the switch a sec or so before actually starting my slooooooooow draw, and keep drawing for a sec or so after release provides more than adequate results. But I have been known to do weird things

 

[sanfordf]

Thanks SWITCHED, I thought something was amiss.

 

[sjohnson]

You want more air if you prefer to draw direct to lungs (AKA cigarette smoking) rather than filling the mouth first before inhaling (AKA hybrid cigar/pipe smoking with cigarette inhale).

I do both, flavor is actually great, though different, both ways.

ETA, I use a pin vise and 50 series numbered index drill bits to enlarge or add holes to my 510 atomizers, and a jeweler's file to enlarge the battery connector air slots. Plus, with larger holes, you can have it both ways - draw slow for a "normal" vape, and faster for a "more air" vape.