ADM adjustment

[k3vin]

LOL..you guys arent tired of my adjustments yet are ya???

THis one concerns an LED holder someone posted in another thread,hope they respond to this one,as I have found a way to use them with the spring mod...

Cut close to edge on the low leg side to make them straight and not rounded so much..

It still wont fit in the cart snug,so you have to sand down the long leg side edges..I put mine on a pencil and use FINE sandpaper..sand,check fit,sand check fit..it needs to go in snug with no warping..only down to maybe 1-2mm..not much at all.




here is the fit after sanding...nice big round holethe long legs go next to spring..

Only cut a very small piece of plug..I use kristins buff pad for mine..

start with a bigger piece,then cut if it stops wicking..mine is just barley bigger than the hole wide,and just long enough to touch spring..works very well..if it leaks,cut another..you just have to fine tune it a bit as liquids are different..
Kevin

 

[k3vin]

oh..if it doent leak but wont wick..cut from the side touching spring...so shorten it just a bit.

 

[k3vin]

LOL..you guys arent tired of my adjustments yet are ya???

THis one concerns an LED holder someone posted in another thread,hope they respond to this one,as I have found a way to use them with the spring mod...

Cut close to edge on the low leg side to make them straight and not rounded so much..View attachment 20528

It still wont fit in the cart snug,so you have to sand down the long leg side edges..I put mine on a pencil and use FINE sandpaper..sand,check fit,sand check fit..it needs to go in snug with no warping..PUSH down to maybe 1-2mm into cart..not much at all.


View attachment 20529

here is the fit after sanding...nice big round holethe long legs go next to spring..

Only cut a very small piece of plug..I use kristins buff pad for mine..View attachment 20530

start with a bigger piece,then cut if it stops wicking..mine is just barley bigger than the hole wide,and just long enough to touch spring..works very well..if it leaks,cut another..you just have to fine tune it a bit as liquids are different..
Kevin

I made a small wording change to the QUOTE for clarification.

 

[k3vin]

dont forget to cut the corners off stuffing material to make it round..

 

[PGVG]

dont forget to cut the corners off stuffing material to make it round..

ALL of your pictures (when clicked on for a closer view) are very blury. Maybe it's in the upload process that makes them that way, but I can't see what they look like, due to the bluryness. Hope you can fix it. Thanks.

 

[k3vin]

Im sorry PG..its a work camera..I just need to use better lighting..will see what I can do...