advice needed - Veritas + dna 166?

[sunnata]

Hello all,

Been a long time since I done any reading and I need some help.

About to order a new mod and I am seeing warnings at vapordna "Never use a short or flat 510 connection on any hybrid or hybrid style device."

I am still vaping with my old Veritas rda and am wondering if I will have any issues with a vaporshark dna 166. As far as I understand, I just need to make sure the center pin sticks out at least 1mm? Is this correct?

Please help, very confused with this hybrid connector and need to place the order today.

TIA

 

[LilWhiteClouder]

hybrid or hybrid style devices are normally applying to mech mods only.... I don't know if I have ever seen a hybrid (hybrid style) regulated device...

I have seen this on many products listing, whether it applied or not.

You should have have no worries using your Veritas on this regulated device. If you were wanting to use it on something like the Rig v2 (has a hybrid style disk with no positive pin), then you'de need to worry about the length of your 510 pin coming outta the atty...

 

[sunnata]

hybrid or hybrid style devices are normally applying to mech mods only.... I don't know if I have ever seen a hybrid (hybrid style) regulated device...

Thank you, LilWhiteClouder. As I said, I haven't done any reading in so long, I was confused by the warnings at their page. So I assume the vaporshark dna 166 is a regular 510?

 

[LilWhiteClouder]

Thank you, LilWhiteClouder. As I said, I haven't done any reading in so long, I was confused by the warnings at their page. So I assume the vaporshark dna 166 is a regular 510?

You will be just fine using that atty on the VS 133w. I miss my veritas (clone). I'll be pulling that baby out tonight