I have had this for a little under a month and I have gotten pretty good at rolling wicks and wrapping coils. The only problem I have with the Aga-T2 is that the positive post that has those little tiny nut type things, NEVER HOLDS THE WIRE! It is always falling out on me because those little nuts never tighten properly. Does mine just suck or do more people have these problems?
Aga-T2 is Disappointing
- Thread starter schotzky
- Start date
- th_trl_thread_readers 0
- Status
It seems some of those nuts strip easy. Take the 3rd one off, and tighten your bottom one counter-clockwise against the top-nut's clockwise.
Try doing this with ribbon...
Try doing this with ribbon...
I can't say that I have found the T2 disappointing, but the nuts on the positive post are certainly a pain. I use two neeede nose pliers to hold the middle ned while tightening the top nut. This has worked well enough to take the T2 out everyday as my main vape
I locked the 2 bottom nuts together. When screwing down the positive connection, I use pliers on both the middle and top nuts. It's a pain, but works. The Smok RSST is much simpler to use with the washer and spring assembly.
- Andy
- Andy
I've been thinking about using a couple washers & a spring from a ball point pen to mod a T2 like an RSST. This 'might' be a good fix for yours if you only have good threads on one of the nuts schotzky.
Tell me about it. HERE's my woes with the Aga-T2.2. I've temporarily ditched it for a RSST, which is working great.
Threading is the same as on the DID, so if you wanted to, you could order replacement nuts from MM or anyone who sells the DID. They would be better quality and nicer looking. I may do this.
If one has stripped nuts or posts, they are available from hoosiervapes...perhaps elsewhere.
Yeah, that DID does have some serious nuts.
Wow, 3 pound 70 for one nut, and then there is international shipping.
This can't be the only iteration of those nuts, meaning they have to be in a hardware store somewhere. Specs for this nut?
Here's the whole set. I found that these all interchange with the AGA whe I used to have a DID.
stainless-steel-contacts-for-the-standard-did-d20
Soon this problems will be a thing of the past... I'm working on making a brass center post and stainless steel top with a single Phillips screw like some of the higher end mods. I will let ya know how it turns out..
might as well buy a new aga, to order some replacement parts from mmvapors including the shipping wouldn't be worth it.
- Status
Similar threads
