All time favourite set up.

Status
Not open for further replies.
Mechanical single 18650 squonkers. At the moment, the SQ with the Haku Venna has been my go to.
Also, the 67 mods neofet with a NarCA rda...


These answers change by the day....

Very nice. I was obsessed with my Broadside and loved the 20700 compatibility but as you say these things change by the day for some of us. At the moment I'm loving my Rage regulated squong with the Dead Rabbit RDA.
 
Mech or unregulated with a simple round-wire coil around 1 ohm is my preferred vape. Current fav is a Dotsquonk with a Vapefly Galaxies RDA.
Is that 1 ohm or 0.1 ohm out of interest? I'm a fan of simple builds myself. My go to build is dual 21g flatwire coming in at 0.1.
 

somdcomputerguy

vaper dedicato
ECF Veteran
Verified Member
    I switch between 2 regs and a mech. I mix up my own juice and build my own coils, close to 2 ohms. I sometimes use a clearomizer that uses a coil head rated at 2 ohms. The reg that I use it on and my multimeter agree with that..
     

    Baditude

    ECF Guru
    ECF Veteran
    Apr 8, 2012
    30,394
    72,713
    69
    Ridgeway, Ohio
    JAC Vapor series B DNA75W regulated mod with Original Uwell Crown Clearomizer Tank
    (0.5 ohm coils @ 30 watts).

    images
     

    sonicbomb

    Vaping Master
    ECF Veteran
    Verified Member
    Feb 17, 2015
    8,363
    23,422
    1187 Hundertwasser
    A no-name Velocity Mini clone, dual 26G Kanthal 11 wraps, 2.5mm ID at 68 watts. Loaded with a DIY Key Lime Pi juice that I've been fine tuning specifically for this atomizer for a couple of years.

    I kid you not, so good that I have to say ".......n.." out loud when I take a hit when it's freshly wicked. No atomizer I own or have ever used even comes close to it in terms of smoothness of airflow, flavor, vapor production and general performance.

    Reduced chamber for warmth and flavor. The design of the AFC allows for infinite variability of air flow while always covering the full width of the coil. Additional variable air holes on top for cooling kamikaze builds.
    The deck speaks for itself. For a number of years and to some degree to this day it has become the standard deck design in many atomizers, and for a good reason.
    Self aligning tab locked top cap, an innovation that started with the Velocity if I'm not mistaken.

    A little factoid that I found out recently -
    The authentic V1 and V2 Velocity are the product of a joint collaboration between Cisco (AvidVaper) and Dino Ferrari. They never produced a Velocity Mini, there is no authentic.
    The Velocity Mini was created by Tobeco as a shorty version of the Velocity. So in the sense that they copied the fundamental design it's a clone, but it is modified and in my opinion highly improved. The V1 has an over sized chamber which affects flavor and airflow. The V2 is shorter (not as short as the Mini) and has a smaller drip tip than the V1 and the Mini, but still doesn't perform as well as the Mini.


    I've used it a number of different mods over the years. Currently running it on a Releaux Gen 3, and a right bloody handsome pairing it is too.

    6OHkQwm.jpg
     
    Last edited:
    A no-name Velocity Mini clone, dual 26G Kanthal 11 wraps, 2.5mm ID at 68 watts. Loaded with a DIY Key Lime Pi juice that I've been fine tuning specifically for this atomizer for a couple of years.

    I kid you not, so good that I have to say ".......n.." out loud when I take a hit when it's freshly wicked. No atomizer I own or have ever used even comes close to it in terms of smoothness of airflow, flavor, vapor production and general performance.

    Reduced chamber for warmth and flavor. The design of the AFC allows for infinite variability of air flow while always covering the full width of the coil. Additional variable air holes on top for cooling kamikaze builds.
    The deck speaks for itself. For a number of years and to some degree to this day it has become the standard deck design in many atomizers, and for a good reason.
    Self aligning tab locked top cap, and innovation that started with the Velocity if I'm not mistaken.

    A little factoid that I found out recently -
    The authentic V1 and V2 Velocity are the product of a joint collaboration between Cisco (AvidVaper) and Dino Ferrari. They never produced a Velocity Mini, there is no authentic.
    The Velocity Mini was created by Tobeco as a shorty version of the Velocity. So in the sense that they copied the fundamental design it's a clone, but it is modified and in my opinion highly improved. The V1 has an over sized chamber which affects flavor and airflow. The V2 is shorter (not as short as the Mini) and has a smaller drip tip than the V1 and the Mini, but still doesn't perform as well as the Mini.


    I've used it a number of different mods over the years. Currently running it on a Releaux Gen 3, and a right bloody handsome pairing it is too.

    6OHkQwm.jpg
    You are not wrong, that is a handsome set up! I have so much love for the velocity! I had a Mini myself but it had a plastic cal which I melted in a mech accident/learning curve. The Gen 3 is a sick mod, Im a massive fan of most wismec products.
     

    tearose50

    Vaping Master
    ECF Veteran
    Verified Member
    Feb 2, 2011
    6,606
    13,873
    Tennessee :-)
    Regulated mod, on the smaller size with 18650 battery or self contained battery. I have several I rotate, both older and newer. Swag, Pico, CB60, Radius and P3 come to mind as most used regularly this year so far. Okay, my favorite is the Radius -- but I am so pleased with a collection. :)

    I also use Kabuki and Zenith 95% of the time.

    I'm a "plug and play" MTL vaper. ;)
     
    Last edited:

    uthinkofsomething

    Ultra Member
    ECF Veteran
    Jun 7, 2015
    2,157
    8,388
    43
    Toledo, Ohio
    My fav was a troll v2 25mm rda with dual twisted coils, 2x 28g and a 26g kanthal, on an IPV8 with the blue crackle finish. I would run it between 90 and 100 watts. The mod died on me and I mostly use an rta now, but the troll had better flavor. I still miss the ipv8, but I dropped one hard and destroyed it, bought a new one and that had internal issues, won't buy another....:cry:
     
    Last edited:

    flavourchaser

    Super Member
    ECF Veteran
    Jun 25, 2018
    630
    1,188
    In the mornings I'm an MTL vaper with the Pulse 80watt, in the afternoon I like my single coil rdas(skyfall,recurve, Narca, Haku venna etc)with the Pulse 80watt. In the evening I like my Pyro RDTA's on my wismec Rx gen3 and gen3 dual. Variety in Vaping is the spice of life. I love them all equally. I can't just pick one. :D:D:D

    My Current Collection.jpg
     
    Last edited:

    Zaryk

    Ultra Member
    ECF Veteran
    Verified Member
    Jan 25, 2018
    2,535
    7,216
    Ohio
    Currently My favorite is my stabwood hybrid Vicious Ant Spade mech squonk mod, Gas Mods GR1 (recently swiched to the small airflow inserts and love it) with an NI80 28x3/40 fused clapton 5 wrap 2.5id 0.31ohm. Bouncing between two of my DIY flavors mostly, pumpkin cake batter and strawberry banana candy.

    20180808_025014.jpg
     
    Last edited:

    QcVaper

    Ultra Member
    ECF Veteran
    Jun 17, 2017
    1,878
    3,707
    Canada/Quebec
    The one atomiser i use all the time is my Drop rda no doubt (maybe the solo eventually)
    Best flavor i've had since i started dripping or using rebuildables.

    Unfortunately there's no 1 mod i like more than the rest, i'm a tech geek so i geek out on tech like this XD
    I'll probably keep buying more until i die tbh :p
     
    Status
    Not open for further replies.

    Users who are viewing this thread