Another variable sweet spot thread

[somdcomputerguy]

I'm finding a 1.3 ohm coil to be to low for me. On my Provari, between 2.9 and 3.5 volts are OK. I haven't used this tank on either of my other two variable wattage regs, but I'd think it to be in the 6 - 7 watt range. It's time to re-wick the other tank or quit typing and do it already. I think I'd go for the former, but then I'd have to think about that. The other tank's coil I wrapped to about 1.7 ohms. My mech and me would be ever so gladder if that tank was fully operational again.

 

[Izan]

Fingers crossed for you mate...Good luck!

Cheers
I

 

[vapdivrr]

When I used my provari 15 watts regulated was the highest any mod had, so I use to run a 1.3 ohm coil at 5v (it's been so long I forgot, I believe 5 is the highest) with that resistance, it gave you the max wattage of the device. If you went any lower with resistance it maxed out the 3.5 amps, so you wouldn't get the full 15 watts, obviously any lower than 1.3 ohms, you also wouldn't obtain the 15 watts....yep, 1.3 was the coil for me when using the provari

 

[somdcomputerguy]

Well I still haven't done a simple re-wick on my Gotank yet. I did come across a clearo (Innokin iClear X.I) I had hidden in one of my drawers. I also found 2 boxes of coil heads (2.1 ohm listed on box). My Provari reads that coil as 2 ohms, and a 4 volt setting on that mod leads to a very nice toke!

 

[Ryedan]

Well I still haven't done a simple re-wick on my Gotank yet. I did come across a clearo (Innokin iClear X.I) I had hidden in one of my drawers. I also found 2 boxes of coil heads (2.1 ohm listed on box). My Provari reads that coil as 2 ohms, and a 4 volt setting on that mod leads to a very nice toke!

Whatever watts work for you is great somdcomputerguy

Lately I'm vaping between 12 - 13 watts and that's doing it just fine for me.

You'll get it right soon

 

[ppeeble]

Makes me nostalgic for the simpleness of 5 years ago. Set your voltage at 2 volts over the resistance of the coil and vape away. Wattage has a lot to answer for !!!