Anyone Have a Tornado Tank Suggestion or Trick????

[Skeeterkck]

Hello Vapers.

I wanted to know if there is a way to make the Tornado tank vape the flavors like you do when you vape from a KR808d-1. I can't seem to get the flavored taste, out of my Tornado tank. Any suggestions, tricks or tips???? Please help!!!!!!

Skeeterkck

 

[BuffaloX]

If you are running dry push the wig in a little, if you are running wet pull it up a little.
Personally I think adding 5-10% Vodka to a pure PG mix works well.
For some reason the taste seems to be at its best, when I hear a lot of sizzling, when I hear that, I have the taste of direct dripping. When I used the original Janty flavor I had that all the time, my own mix is not quite there yet. I think I may need to add a little VG.

 

[Mr.Tokes-Alot]

The only other tip I can think of, is leave a quarter inch or so of the tank empty (don't fill it to the brim). Other than messing with the wick bit inside the atty like the post above states, that's about it. Hope this helps a bit.

 

[mwa102464]

Hello Vapers.

I wanted to know if there is a way to make the Tornado Tank vape the flavors like you do when you vape from a KR808d-1. I can't seem to get the flavored taste, out of my Tornado Tank. Any suggestions, tricks or tips???? Please help!!!!!!

Skeeterkck

I have the same issues along with plastic taste in my vape from these, back to LR 2ohm Attys on my Ego's with a drip tip. I wished they would make stainless steel tanks to put the liquids in instead of plastic and 3ml's per tank along with opening up the pin in the Atty just a tad and using a wick that the liquid would pass through a bit better without that metal helmet on the top of it, I think these would make for some nice changes, until then 2ohm Ikenvape 510 Atty's on my Ego/Riva/Tornado's !

 

[Pur3Rush]

lr tank attys are the way to go. Waaay better than the normal tank attys, cheap, and last a long time even though there's no warranty. Easy to clean, just run under hot water using tongs, blow out, then dry burn and use. Good flavor, no messing or fiddling with it like normal tank attys. The best of the best.

 

[Dan Patrick]

You can get about 20 percent more vapor by taking a small screwdriver and taking the end off the tip and removing the other piece under that, another plastic piece that just pops out of the carts. I love it. Then you can even get a rubber cap with a hole in it from Heaven Gifts (at least that is where I found them) to tighten up the draw. Here is the video I got the tip from.
YouTube - eGo-T Tank follow up LR low Res attys and some tips & tricks WINNING