anyone know where i can get...

[Stinkytofus]

Kepler 510 Finned Heat Sink for Atomizers

i dont think there is something like this but cant hurt to ask, i have this kepler 510 heat sink, works great, but i dont like adjusting the screw, is there something that can replace the center pin with a floating or spring loaded 510 pin? that way i can screw this on the mod, then screw my tank on, easy~~

 

[crxess]

FastTech - Gadgets and Electronics

 

[Stinkytofus]

i was wondering if there is a floating or spring loaded 510 that i can get somewhere to use with the kepler heat sink (the kepler uses an adjustable 510)

 

[crxess]

i was wondering if there is a floating or spring loaded 510 that i can get somewhere to use with the kepler heat sink (the kepler uses an adjustable 510)

You will need to replace the complete sink. Designs are specific.
Page 2 of that link has an SS solid pin sink.

 

[Stinkytofus]

okay thanks, lemme check it out

 

[puffon]

The VLS uses a floating copper pin. Not spring loaded tho.
Vulcan HS | Vapour Life Style (VLS)

 

[Stinkytofus]

the kepler has two screws, one from the bottom and one inside, the one inside gets wobbly the higher it comes up, and if its too low it wont make connection, and when its wobbly the reading can go up .10-.40 ohms, the heat sink definitely works, my mod is a lot less warm but i was hoping to find something that is spring loaded and not adjustable, the vulcan vls one looks like adjustable as well

 

[puffon]

The pin does have a "slot", but turning it will not adjust it.
The pin just floats up and down.

 

[Stinkytofus]

The pin does have a "slot", but turning it will not adjust it.
The pin just floats up and down.

so lets say if i put the vls vulcan heat sink on an mod, the vls bottom pin will push against the mod and make a connection, then i screw on my tank on top of the heatsink and it will press against the top pin of the vls heat sink?