Anyone use the Kanger Pro 3?

[93gc40]

If anyone has used the Kanger Pro 3 tank, maybe you can answer something, for me. Can the Pro 3 be used on a 1100 eGo-T battery? I have one comming in a couple days, best battry I have right now is the 1100 eGo battery and a 900 ego.

Yes, that was my starter setup.. Still is my Backup vape. Wife still uses an original Protank. Of course I quit buying factory dual coils after the first 10. Started rebuiling them to vertical coils at 1.5-2ohm. Better vape less leak and gurgle.

 

[orlasbats]

its a pretty good tank.

 

[sbranoff]

Finally recieved my Kanger Pro 3, it came with 1.8 coils, I also got a Vision 1650 Spinner 2 battery. With that coil and battery, what volt should I set the battery at? It goes from 3.3v to 4.8.

 

[sbranoff]

Will the Spinner 2 1650 VV battery handle the 1.5 coil on the Kanger Pro 3? What volt should I set the battery to?

 

[Larry J]

I use the 1.2 ohm coils in my PT3s on Ego2 style batteries (2400mah) for my less-preferred juices and they work fine. The 1.5 shouldn't be a problem. As far as a voltage setting it will depend on what you like personally. Start at about 3.3v and work your way up gradually until you start getting a slightly harsh or burnt taste, then back it off a bit. Your optimum setting will likely vary from one juice to another.

 

[sbranoff]

Will a 1.5 improve the vapor and taste over the 1.8 coil in the PT3?

 

[sbranoff]

I think, I'll try the 1.8 cotton coils, the 1.5's seems hard to find.