Aspire Atlantis & Cuttwood Unicorn Milk

[Ennsem]

Hey there ladies and gents,

My set up is currently a Cloupor T6 with an Aspire Atlantis.
I just bought Cuttwood's Unicorn Milk a few days back and Im getting "dry hits" when my coil isnt hot enough.
I change to a new coil whenever I change eliquids.
This is the first time Im getting initial dry hits from the Atlantis and previously my eliquids are menthol based.
I am vaping the Unicorn Milk at 23watts.. Only after the coil heats up, my vape will be a smooth one..

Am I doing something wrong here or is it just the nature of Unicorn Milk to be like that?
Also Im getting a faint strawberry flavour and a more distinct cream/milk taste.

Thanks in advance for any advice!

 

[Katmar]

Bump for an answer. Good luck..

 

[BigCatDaddy]

I run my Atlantis at 35 watts, smooth, warm vape. Also make sure that the holes in the coil and the slots in the base line up so it lets maximum juice in. You might also try giving the Atlantis a couple of unfired draws before firing it. It's not the juice though.

 

[BluzKing]

When changing coils in the Atlantis, actually put two or threes drops of juice directly into the coil to "prime" it before putting the tank back together. Wait a minute or two and then give it a shot. Always works for me! Good luck....

 

[Ennsem]

Yeah the holes in the coil and the slots in the base line up and i did unfired draws before firing..
I've also primed it first..

Someone recommended to vape the Unicorn Milk at 15-20watts.. lets see if this setting works...