- Status
Can you remove the pin? Looks like a manually adjusted 510 from the pics, and those will usually bottom out and stop turning when you reach the lowest point. If yours is spinning, perhaps there's an issue with the threads?
Yeah this happens allot... not all 510 sockets are as deep as others...... I use spacers to fill the void. Old orings or pieces of fabric work great or washers.
Sent from my SCH-I605 using Tapatalk
Sent from my SCH-I605 using Tapatalk
Better too shallow than too deep. A rubber washer should do the trick if it bothers you.
For 22mm atomizers there is this product that might help.
$2.35 Replacement PC Heat Insulation Gasket for Atomizers (5-Pack) 5-pack - for 22mm diameter atomizer at FastTech - Worldwide Free Shipping
I use this type of spacer with my rda. I need the single air supply in my SV rda clone to be facing away from me taking a puff. The single coil can be built in several locations.and the spacer can help position the deck so a coil can be built where I need it to be. So far I've been using hand made shims that are thicker but I also have some of the thinner ones from FT.
Try these;
$6.44 510 Heat Dissipation Heat Sink for Atomizers (5-Pack) 5-pack - stainless steel / 24mm diameter at FastTech - Worldwide Free Shipping
They serve double duty. Once installed onto the mod. The 510 threads of the mod are protected from atomizer change out cross threading. If the atomizer does not set flush its not as noticeable as it looks like the fins.
FYI: Click on "model" to choose different sizes, colors, ect.
$6.44 510 Heat Dissipation Heat Sink for Atomizers (5-Pack) 5-pack - stainless steel / 24mm diameter at FastTech - Worldwide Free Shipping
They serve double duty. Once installed onto the mod. The 510 threads of the mod are protected from atomizer change out cross threading. If the atomizer does not set flush its not as noticeable as it looks like the fins.
FYI: Click on "model" to choose different sizes, colors, ect.
i took it apart and it seems to just push it self against i assume its delrine. everything looks pretty solid on it i thought maybe the vaperz cloud rdas will fit on it ? i realy like the mini buddha it seems to be a bit smaller 510 than normal but i could be wrong
it just look a bit excessive to me 13 mm is a bit too high i might go with the 22 mm washers the tank and the mod where the tank are is all black so i think it will look pretty slick
That is package dimensions. It doesn't list product dimensions. If it did they would be on the top left of that bottom section.
its not like it just spins at the button you can fell when it hits the top of the the delrine plate. but do you think it whould fit perfectly with other vaperz cloud products like the glacier or mini buddha all the reviers ive seen have a glacier on it ?
About 1/3 of the Mods I own have a gap between the Mod and the Atomizer. Something that Really Bugs me.
I used to cut out Thin Plastic or Vinyl and then punch out a Hole with a hole puncher to "Shim" them.
Then I found these...
KP Mod Guard 5 Pack- Various Sizes
... and Life is Good.
i just picked up a 5 pack of these from fasttech along with some other stuff that might be the only solution to this problem
Shimming your Atomizer is an Easy way to go. And the Pre-Cut ones are barely noticeable. It's just a matter of finding/using the right Thickness.
- Status
Similar threads
- Locked
