Atty break in

[SMKNOMOR]

How do you guys like to break in your atomizers and how long does your method take till full optimization?

 

[Mr.Self_Destruct]

Depends on the atty and depends on the juice.

 

[IOU]

True, depends on the atty for sure, but I like to clean, blow out and vape. It usually takes a couple of days worth of vaping to really see the beauty (or lack there of) of the atty.

 

[SMKNOMOR]

Depends on the atty and depends on the juice.

How so? I've been using carto's. I figured I would try Attys for once a change and I'm not too impressed yet buy it's only been one day on one 901 atty. I ordered a few different kinds tho.

 

[fallon74]

I start off with blowing the primer out of my atty. It takes a couple of days for full optimization.

 

[Nomoreash]

I blow it out then do an alcohol soak to get the remaining primer and any other contaminants out, blow it out again and do a dry burn. After that I've never noticed any break in time.

 

[donnah]

I just blow out the primer and drip... I love a new atty!

 

[mwa102464]

I blow out any primer than I put a condom from a carto on the bottom of the Atty, I then take whatever flavored liquid I'm going to run in that Atty and I fill the Atty up to the top of the bridge and I than let that Atty sit like that for about an hour. This ensures that my wick gets completely soaked and my Atty's never get that burnt taste, many people just put a couple drops in and fire there Atty, this is risking the wick gets a slight burnt spot on it sometimes and I don't ever get that because its never the same once its burnt, thats my reason for the initial soak to prime it properly, this works every time.!

 

[grandmato5]

Blown out the primer and dripped a couple drops of juice in, insert cartridge and four of mine were good to go. I did have three that had a really hard draw and not working well at first try so before contacting the vendor I did a 15 soak on alcohol and let them dry over night and the next morning dripped the couple of drops of juice in, inserted the cartridge, and they were worked fine. Never needed to do anything else to optimize an atty. I've only started 7 new atty's in the past 6+ months and six of them are still working fine so I guess there's always a chance I'd need to do something else at some point in the future but I'm not thinking so.

 

[SMKNOMOR]

I blow out any primer than I put a condom from a carto on the bottom of the Atty, I then take whatever flavored liquid I'm going to run in that Atty and I fill the Atty up to the top of the bridge and I than let that Atty sit like that for about an hour. This ensures that my wick gets completely soaked and my Atty's never get that burnt taste, many people just put a couple drops in and fire there Atty, this is risking the wick gets a slight burnt spot on it sometimes and I don't ever get that because its never the same once its burnt, thats my reason for the initial soak to prime it properly, this works every time.!

That sounds like a great suggestion. thanks so much.

 

[TheRMovie]

I got a 2om ikeenvap 510 and trying to break it in is a real pain lol. It took a while to break in the mini 801 also at first I hated it now it's the best atty I ever tried lol. To break an atty in ya just have to keep vaping on it and stick with it in end it worth it.....most times.