• Need help from former MFS (MyFreedomSmokes) customers

    Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?

    View thread

AW Batteries & Pila Chargers at Super T ~Great Prices Super Selection!

Status
Not open for further replies.

clyde2801

Vaping Master
ECF Veteran
Verified Member
Dec 13, 2009
4,039
3,173
In the land of no hills and red dirt
Heres the dimensions on the AW IMR 1600mah vs 2000mah. The new IMR 2000mah is about 1mm longer:

1600mah: 2.558
2000mah: 2.596

As far as load testing: In progress, i need to charge and discharge them about 4 cycles before the reading levels out.

So would we have to change washers, o-rings or anything else to use them, or would it be the same for the IMR 1600mah?
 

forcedfuel50

Unregistered Supplier
ECF Veteran
So would we have to change washers, o-rings or anything else to use them, or would it be the same for the IMR 1600mah?

Good morning Clyde!

Two thin .070 orings under the battery would be a good starting point and three washers under the rhodium post.
 

forcedfuel50

Unregistered Supplier
ECF Veteran
The new AW IMR 18650 2000mAh are in stock. Remember to post up your order number to be entered in the drawing for a free custom PrecisePlus 18650!

If it won't let you order, refresh the page.

To order visit:Super T Manufacturing, Innovative manufacturer of electronic cigarette products.

IMR18650 -2000 Specifications

Nominal Voltage : 3.7V
Capacity : 2000mAH
Lowest Discharge Voltage : 2.50V
Standard Charge : CC/CV ( max. charging rate 2A )
Cycle Life : > 500 cycles
Max. continuous discharge rate : 10A
Operating Discharge Temperature : -10 - 60 Degree Celsius
 

forcedfuel50

Unregistered Supplier
ECF Veteran
Pila chargers are back in stock!

If it doesn't allow you to order, try refreshing the page.

To order, visit: Super T Manufacturing, Innovative manufacturer of electronic cigarette products.

Pilaibc1.jpg
 

forcedfuel50

Unregistered Supplier
ECF Veteran
Here are the test results of the AW IMR 18650 1600mAh vs the 2000mAh. Test was performed at 2.5 amps which is the approximate draw of a LR 1.5ohm atomizer. The winner? It's a tossup.


Through most of its life, the 1600mah does hold slightly higher voltage under load .

Though total tested mAh of the 2000 was almost 400 more, only 200mAh of it was "useable" and only when using vari voltage/wattage devices (assuming we change out the battery by 3.3volts which is when the Kick by Evolv automatically shuts off). The other 200mah was gained when the battery was under 3.3 volts.

My opinion. If you are running vari wattage/volt mods, run the 2000mAh as you will gain maybe another 1/2 to 1 hour run time.

If running mechanical or non VV mods, run the 1600mAh for its added ability to hold voltage under load. If you change your batteries out at 3.5 volts, you gain no mah by running the 2000mah and it can't hold voltage as well as the 1600mAh.

1600v2000.jpg
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread