I have a bad connector in my BB which is only 2 months old! The pin moves very easily and stays to one end whichever is push it to and it's almost an 1/8 of an inch. I have bad connectors on 2 tvf4 micro tanks as well. The ohms will jump all over the place or not register at all. Is there any way to repair these? I have ordered a new tank which is most certainly not a smok. But I feel the BB should've lasted longer than 2 months especially since I take real good care of it. If I screw the tank down only half way I can get it to work sometimes. Also I put my friends brand new BB on my mod and it works fine. Also I'm using an rba but all the screws are secure and it's a .3 ohms build which I've used plenty of times. I would really appreciate any help thx in advance.
Bad 510 connector in baby beast tank...
- Thread starter Brian Acree
- Start date
- th_trl_thread_readers 0
- Status
Welcome @Brian Acree and I hope you enjoy your stay.
Question have you checked and are sure it is an Authentic Baby Beast? And with it only being 2 months old have you inquired into the warranty? Many devices come with more of a warranty than 90 days which you are way under.
Question have you checked and are sure it is an Authentic Baby Beast? And with it only being 2 months old have you inquired into the warranty? Many devices come with more of a warranty than 90 days which you are way under.
Yes I'm pretty sure it's authentic I haven't checked the code but the place my friend got it is pretty reputable but I will double check. And it might be over 90 days old cause it was a Xmas gift my friend is checking the receipt. Thx
- Status
Similar threads
- Locked
