WRONG
These are both Regulated mods.
YOU USE POWER (watts) DIVIDED BY MINIMUM BATTERY VOLTAGE
Ipv3 li v2 for example
6.2V minimum input voltage
200 watts maximum output after firmware upgrade...
Since the batteries are in series to get that voltage, they'll both see the entire current.
Which with 6.2V from the batteries and 200W output to the atty comes to a whopping...
32.25806 AMPS BEFORE EFFICIENCY LOSS (WHICH MAKES THIS NUMBER BIGGER BY 5% TO 20%)
DANGER!!!!!!
Tapatyped
Did you not see SINGLE battery bolded in my previous post? You saying SteamEngine is wrong?? This...
...tells me my batteries are at 4.2v when I take them off the charger. You saying that's wrong,too??
The example I gave was for 1 battery, 1 - .5 ohm coil. I didn't specify a device/mod.