Battery Charger for Ultrafire Protected CR2/15270 Li-Ion Battery

[nocturn4l3030]

Simple question, I bought these Ultrafire Protected CR2/15270 Li-Ion Battery, 3 Volts for 6 volts in my Alpha.

I have this charger Ultrafire 3.6 volt or 3 volt RCR123 Lithium Battery Charger for my AW LifePo4's. Will this work for the Ultrafire's I bought?

If not, can someone link me to the correct charger on madvapes.com (if they have it)?

Thanks

 

[nocturn4l3030]

bump to front page

 

[nocturn4l3030]

never got an answer for this >.<

also.. these come off the charger stacked at 6.6-6.7 volts.. for safety precautions (if the protection circuit fails), what voltage should i take the batteries out at?

 

[Nomoreash]

I've had the WF-188 for about 8 months with no issues, selectable 3.0 and 3.7v and 2 charging speeds along with being able to charge many different sizes. I'd recommend it unless you want to go with Pila but those will cost you twice as much or more.

I have no experience with 3v batts but I try not to let my 3.7s go below 3.5 before charging and usually before then. 3.7 batts come of the charger at 4.2 or just under.

You'll need a multimeter to check the voltage if you haven't already got one, check Harbor Freight if you've got one close, they usually have great deals or you can get them online many places.

 

[nocturn4l3030]

thanks for the reply, ya i already got that charger, so im happy to hear i can use that.. just wanted to make sure before i go blowin up something >.<

ya.. using 3.7volts it's easy to know when you need to replace em cuz your hits just get weak... i got a multimeter just tryin to figure out what's the voltage that it gets dangerous at