batts and charger for Sigelei 150 watt Box Mod
- Thread starter clamman
- Start date
- th_trl_thread_readers 0
- Status
Xtar VP2 - RTD vapor
Xtar VP4
get the flat-tops, coupon code LV15 for 15% off or LV10 for 10% off
Sony 18650 VTC4 3.7V 30A 2100mAh Battery FLAT OR BUTTON | Lightning Vapes
Samsung INR18650-25R 2500mAh - RTD vapor...... these would be my second choice, just my
Xtar VP4
get the flat-tops, coupon code LV15 for 15% off or LV10 for 10% off
Sony 18650 VTC4 3.7V 30A 2100mAh Battery FLAT OR BUTTON | Lightning Vapes
Samsung INR18650-25R 2500mAh - RTD vapor...... these would be my second choice, just my
The above suggestion for an Xtar charger is a good one.
I also agree with the suggestion for the Sony VTC4, Samsung 25R, or LG 18650HE2.
I also agree with the suggestion for the Sony VTC4, Samsung 25R, or LG 18650HE2.
Depends. Does your particular mod require flat tops? If not, you could go either way.
I happen to believe button top batteries are a little safer to use, in particular in a mechanical mod. Button tops generally have vent holes in the "button", which theoretically would allow hot gas to vent more easily should the battery go into thermal runaway. (That's better than actually blowing its top off -- that's an explosion.) I've yet to see a flat top battery have vent holes.
Sigelei Needs flat top batteries, button top wont fit unless you want to hammer them in.
i checked the link to LV above and he has 68, 2-packs of flat-top VTC4's for $19.75 at 10:44am EST.
vtc5 > vtc4 > samsung inr 25r > lg he2, i would get 4-6 batteries if you using sigelei 150w... i chain vape... 2 batteries last me less than half a day... dunno how people use it for three days... lol
flat tops > button tops unless your mod can fit button tops
vp2 > vp4, get two vp2 or 1 vp4
flat tops > button tops unless your mod can fit button tops
vp2 > vp4, get two vp2 or 1 vp4
Yep ditto on the battery life - I get half a day each out of a pair of VTC4's and a pair of Samsung 25R's. That's a mix of regular vaping and chain vaping at around 50 watts. The Samsung's give a tiny bit of extra life, but not much considering the situation.
Are there any other batteries around with higher capacity that would work here?
To my knowledge, 2500 mAh is the highest capacity of any high drain IMR battery. Any battery with more mAh is likely an ICR chemistry battery and not fit for personal vaporizer use (especially sub ohm).
I save my Sonys for my mechs. I usually run LG HE2 or MXJO yellow (same cell as LG) in parallel regulated mods.
I'm ok with the 20a instead of 30a CDR in exchange for a little more capacity.
There is no reason to run a super low build in a high watt box.
I'm ok with the 20a instead of 30a CDR in exchange for a little more capacity.
There is no reason to run a super low build in a high watt box.
My sony, mnke, and MXJOs that are flat top batteries have vent holes...I'm confused...
My appologies.
I do now recall that my old Sony's had vent holes. I've never used MNKE or MXJO's. The only flat top batteries I now have is the Samsung25R and from casual look it appears they have no vent holes, but getting out my magnifier they do indeed appear to have vent holes. Excuse these tired old eyes.
- Status
Similar threads
