BB and GJ in Tanks

[Drip Drops]

I've got 4 100ml bottles of BB, a 30ml bottle of GJ, and an 18ml bottle of PG Hype. Definetely got a lot of AVE right now.


Was just using plain Boge LR 2.0 cartos and all was working well, but recently got a Mini-Submarine Tank from momandpopsvapor shop.

The first load in the tank was BB, and it worked well. But the carto became really burnt tasting after like 3 days.

I'm thinking that the VG may be a little too thick to use in a 2 hole punch Boge LR carto.

What is everyone doing to make thier juice work at top performance in Tanks? Thinning a little bit perhaps?

 

[Killjoy1]

Thinning could help, but will reduce both your nic content and flavor strength a little bit, depending on how much you dilute it

BB is pretty hard on cartos and I get much less life out of them with that juice (2-3 tank fills). Other juices like the GJ and Root Beer I probably get 5-6 fills on the tank before the cartos get nasty. Overall I've had good luck with AVE juice in tanks, two holes punched in the cartos, but BB sometimes requires a little extra (either one more small hole or slightly larger holes). YMMV, of course

 

[Roxxette]

I hammer 3 holes in cartos with VG juices

 

[fenderbc]

Me too. 3 holes in IKV fusions for GJ and BB.

 

[Drip Drops]

Three holes in a Boge LR 2.0 Ohm Carto?

Two in the bottom and up higher up? What would be the best locations for holes ?

 

[Roxxette]

Same way , just 3 what i do is put 2 in each separate side then another in the middle of the 2.

 

[JollyRogers]

I use a Genisis atty mostly... they will work great with AVE if setup right. Also, my best performer is my UFS w/ the Patriot rebuildable atty for UFS...1.5 turns on juice control, 1 turn on air, 5 wrap 32g kanthal coil, using ODY wick. I get so much flavor and vapor, that it actually beats out my genny atties... and I can't see to drive unless I blow the vapor out a window!!! The only draw back, I have to change the wick/coil about every 3-4 days because they start to crud up and get a slight burnt taste. But it is cheap to do.

Never tried to run BB/GJ in a carto. Have used it for dripping on a dc 510 with great results also.

 

[Porphy]

I use a Genisis atty mostly... they will work great with AVE if setup right. Also, my best performer is my UFS w/ the Patriot rebuildable atty for UFS...1.5 turns on juice control, 1 turn on air, 5 wrap 32g kanthal coil, using ODY wick. I get so much flavor and vapor, that it actually beats out my genny atties... and I can't see to drive unless I blow the vapor out a window!!! The only draw back, I have to change the wick/coil about every 3-4 days because they start to crud up and get a slight burnt taste. But it is cheap to do.

Never tried to run BB/GJ in a carto. Have used it for dripping on a dc 510 with great results also.

I need to look into these rebuild-able attys. A lot of folks think I stay in the loop on devices doing what I do but the truth is I'm so damn busy everyday I get to stop by here to get my information LOL. It's either come here for valid feedback on new stuff or trust the suppliers...which is fine, I guess, but I'd rather have someone go through the ins-and-outs of a device before I give them a whirl.

 

[Roxxette]

You should Phorpy and the time couldnt be better with so many options at the moment.

 

[Killjoy1]

Since you're a Reonaut, maybe you should get in on Scubabatdan's co-op when he runs one for his BFG. That's one that a lot of people are eagerly waiting for, though it's probably still a ways off. I love my rebuildables, past and present, but haven't quite gotten peak performance out of a genesis setup, yet. They're nice, but so far I prefer silica wick to mesh

 

[aliens]

Me too. 3 holes in IKV fusions for GJ and BB.

What kind of tank do you use for the IKV fusions?

 

[Killjoy1]

pretty much any carto tank will work. I've used them in several different makers' tanks. They're the same length and diameter as a regular Boge (the mega Fusions are the length of an XL carto).

 

[unloaded]

For tanks and BB I've had best luck with single hole and drilling it out with 1/16" drill bit. I'd get a little bubble every hit but no flooding even if it sat for a long time. Right now I'm using my new Odysseus and it's working great with BB. I've got the coil at 3 ohm and run it from 4.5v to 5.5v depending on my mood. No flooding and no dry hits. About one full turn on the flood control. COV is getting a batch of them in this week so now is the time to grab one if you've been thinking about it. If it turns out they aren't for you, you'll have no problem recovering your funds.

 

[fenderbc]

What kind of tank do you use for the IKV fusions?

Just like Killjoy1 said, any tank will work. I have them in DCT (xl), liquinator, j-tank and m1a1 tank.

 

[kaptkobe]

I'm lovin BB in my nova 2.5.

Also works great in a sub tank with a phoenix xl.