I've done some searching on these and can't find what I'm looking for. What's the best 510lr atty. Which 510lr atty should I buy. Looking at these because I want to experiment with dripping. I believe the cisco's might be good but not sure. So I did some research and couldn't find where I could buy them. thanks
Best 510 lr
- Thread starter ledouxmike
- Start date
- th_trl_thread_readers 0
- Status
avidvaper.com for the Ciscos. Right form the man himself. IMO you are looking at the right ones! If you do not like a real warm vape the 2.0 ohm ones are nice too. Or go big with the 1.5ohm. For dripping the LR 306 is the real animal in my book and it will fit your 510 gear. Get the 2 for $19.99 w/a DT deal. Just make sure it is not a small batt you are driving them with
Thanks for the quick reply and info. What battery source or units should be used when running a LR?
And do the 510 and 306 have the same threads? thanks
And do the 510 and 306 have the same threads? thanks
I read about those. Heard some good things about them. But I'd like buy from the states. But thanks for your suggestion.
Can i run these on a 900mah ego battery? I hope I don't have to buy some more hardware. Can I just run the cisco 2.0 ohm lr's on the ego battery if the answer is no. I don't think I need the 1.5 ohm
Last edited:
Yes 900mah will drive LR. Also 306 and 510 = same threads. Do note that if you are using an eGo type batt there are risks associated w/using LR but I have found they are outweighed by the rewards. Just understand you will be putting a greater load on the batts, charging more and effectively shortening their useful life. Some members have also had eGo type batts crap out using LR1.5's. I run MODS mostly but will still pop a LR 1.5 on an eGo and vape away and they have not killed any of my eGo batts yet. Just wanted to point out that it can happen. Hope that helps
thanks. I was just reading through some threads and read the mosfets in the battery can fail from lr use. Maybe the cisco 2.0 would be safer on the battery. What's the standard resistance on a regular 510 atty? 2.5?
Last edited:
Exactly but IMO once you try LR it is hard to go back to a standard 510 atty on a 3.7 type batt system. I hope you like them
I checked out Ikenvape and they're out of the 306lr and 510lr. The reviews on the products looked very good and they're both 2.0 ohms but out of stock.
Watch the Iken site. His newsletter this weekend said he is expecting a nice sized shipment this week. Cisco or Iken you can't go wrong IMO. They hold the gold standard in atty's. For cartos (I know they are out of stock) the Iken V2 gold are really nice if you use cartos.
Yea I would also recommend Ikenvape's 2.0 ohm atties best I have tried so far that I could purchase in the states.. They seem to be pretty popular amongst everyone hence the reason they always out of stock. Good luck finding what you are looking for and hope you enjoy them once you get them.
- Status
