Best solution for cleaning out Sub Tank Mini??

[TheAtomiser]

I'm currently using the 1.5 Ohms OCC and looking to clean out my tank so I can try the 0.5 Ohms OCC out so I can see which one I prefer

Whats the best solution for cleaning out the tank and coil?

 

[EBates]

Drop your 1.5 ohm occ in a shot of pga. Rinse out your tank and base in warm tap water, dry and install your new .5 ohm occ, fill the tank, and away you go.

 

[Boden]

To clean out the tank just rinse it with water.

The coils can't really be cleaned but you can try the old "soak it in vodka for a day" trick. Once it has soaked take it out and let it dry on a paper towel.

 

[TheAtomiser]

Cheers for the advise guys! What's PGA?

 

[EBates]

Cheers for the advise guys! What's PGA?

vodka or everclear = pga (pure grain alcohol).
I've also used isopropyl 91% that also works well. But be careful to get all of the iso dried out. Iso is Poisionous.

 

[bluecat]

PGA is pure grain alcohol.

I clean my STM by using hot water and some dish soap to break up the VG, PG and flavorings. A soak for an hour or 2 maybe. Blow dry. Pat with paper towel.

 

[TheAtomiser]

Looks like I'll be buying some cheap vodka then

 

[sparkky1]

Dawn / warm water .........

 

[Alien Traveler]

Looks like I'll be buying some cheap vodka then

Better buy bourbon. To celebrate your new tank. Wash tank with water.

 

[TheAtomiser]

I'll wash the tank with warm water, soak the coil in vodka and by myself some Jim Beam

 

[Alien Traveler]

I'll wash the tank with warm water, soak the coil in vodka and by myself some Jim Beam

Do not touch coil! It is much better as is, without ANY cleaning.

 

[TheAtomiser]

I got inpatient and cleaned everything with warm water and fitted my 0.5 Ohms OCC and blueberry crush

 

[David Wolf]

I'm currently using the 1.5 Ohms OCC and looking to clean out my tank so I can try the 0.5 Ohms OCC out so I can see which one I prefer

Whats the best solution for cleaning out the tank and coil?

I take out the coil, turn on a stream of hot water and rinse the tank and base in the stream, shake out the water from the tank, twist up a paper towel and wipe out the inside of the tank air flow tube real good, blow water out of the base and again with the twisted end of a paper towel wipe out the inside of the base. I don't wipe the glass down, a minuscule amount of water doesn't hurt a thing. That gets the old juice out just fine. Pop in a new coil, prime with a few drops in the top of the coil and the wick holes (a drop or two), fill the tank, screw the base on and good to go. About a five minute affair. Take a few unfired puffs and let sit upright a few minutes to saturate the wick. Vape at lower power until you get good vapor and then set as you wish.

 

[David Wolf]

I got inpatient and cleaned everything with warm water and fitted my 0.5 Ohms OCC and blueberry crush

There ya go.