blu PCC have no idea!!!

Status
Not open for further replies.

WebMistress89

Super Member
ECF Veteran
Verified Member
Dec 14, 2011
578
707
35
Canada
www.rhiannagreene.com
I just got my blu.... I see where in the pack i am supposed to put the e cigg to charge.

BUT it wont screw in and it doesnt light up and the manual doesnt say much about it.

I have no idea if its charging and it doesnt screw on at all it just sites in there and when i try to screw it in nothing happens.

And the side lights dont light up at all.
 

faux_sheaux

Full Member
Dec 11, 2011
37
16
Honolulu
My mom has one. Don't try to screw the battery in! You simply drop the batt thread side down into the upper right hole(if you look in it, there's a tiny spring at the bottom) and close the pack. The bottom set of led's should start blinking after a few seconds to signal that it's charging, and will remain blinking that way until it's done. Probably the most easiest to use pcc I've seen.
 
Status
Not open for further replies.

Users who are viewing this thread