Bolt - DOA

[layer]

Well, that's disappointing. Bolt arrived in the mail today, won't fire any of my atomizers. Guess I need to try to send it back.

 

[livi0073]

Have you made sure your center pin connection is making a connection to the 510 battery connector?

That is where I would start. Check if any cartomizers or other atomizers are working with it. Batts fully charged, etc.

Sounds redundant, but you never know!

 

[salemgold]

I have no clue if this will help you but have you tried pulling the center pin down on your attys? Or if there is a center screw on the Bolt, are you able to pull it up a bit? It could be that your attys are not making contact. This is a common issue with some mods.

If you know that it is getting power, just not firing your attys, it would be worth a shot.

Good luck to you.

 

[twohandedcreations]

Try the center pin thing that everyone is talking about on the atty's B4 you send it back..... Just because your other PV could have a high center pin that pushes the pin on your attys up. Or try a brand new atty or carto...... If nothing, then send it back!!

 

[layer]

Thanks for responding!

I am using a fully charged, brand new AW IMR 18490. I have tried several different attys (including a brand new one), and even a Stardust & EMDCC on an extension.

When I meter the battery I get 4.15 v. When I meter the 510 connector I get about 2.8 v when I first push the horn button, then it goes down.

 

[Martö]

That's a sign of a faulty wire or button.