Boro Mod's, Tanks, Attys And More

[ShamrockPat]

the only good part is, it has a DNA60 inside.

I'd add that it also has a 21700 battery, is the same height as a standard BB, and can use any boro unlike the standard BB.

 

[englishmick]

Find my post if you don't want to spring a leak on your tanks, I have multiple post with pictures on the Sxk BB thread.. good luck!
TGIF, Have a good weekend guys....

Thanks Bad. Took a bit of searching but I tracked it down. Like you said there is a whole bunch of discussion about that issue with several different suggestions. Too much to take in right now but I saved the link so I'll start working on it.

I love the vape I get from the Xeta but it's always been a struggle. Nice to know there are ways of dealing with it.

 

[dwcraig1]

Here's a tip that I want to pass on for any one with one of these Rekavape clones or the OG for that matter. The positive post on the mod has a nylon washer under it while the OG has a silicone washer to prevent liquid from seeping into the mod. At first I was going to replace the nylon washer with a silicone one but came up with something I thought would be even better.
A small dab of dielectric silicon grease under the washer.
Soon after when I first got the mod I found juice around the edge of the screen and inside under the button panel.
Applied my fix and have not had any problem since. I just now pulled of the front panel to check before posting this.
The may be useful for use with other mods.
Pictured is the mod with screw and washer removed and then assembled using dielectric silicone grease under the washer. The silicone grease will not run and e-liquid can't get past it.

Juat a repost for those that need it.

 

[crss]

The old Hirano Tycoon

body swap, green honeycomb

 

[Tor R]

Ground Kloud Innovation Se7en, dot platform, dimensions:
79 x 45 x 22 mm

 

[englishmick]

I blame the switch from bottom fill to top fill. Bottom fill worked just fine.

Top fill causes a slight pressure instead of a vacuum at the top. Thus, flooding is likely until a vacuum is created.

What I do is to top fill, button it up and flip the boro upside down. This causes what bottom fill did. This releases the slight pressure out the wicking since air doesn't flood the coil. Even if the boro is so full of liquid and it is at the wicking. That's ok, since the pressure is lighter at the top and more at the bottom. Air is still better.

Wait I dunno 15 seconds to a couple of minutes depending on the tightness of the wicking and the thickness of the juice. Should be fine now.

Must admit I didn't really understand the theory here. This morning the Xeta tank was almost empty, I filled it up and sat the BB upside down with the back panel on. Left it for about 15 minutes. When I picked it up the inside was dry as a bone and it still is.

thanks Bill

 

[badinfluence357]

I must admit, the BBM mods are super light even wiht the bigger battery..

 

[badinfluence357]

Feeling nostalgic again...

I lost one of Ti hybrid driptips, I looked for it everywhere and found this little mod.
The Good Old Day's !!!

Waiting for a delivery of eliquids that I had the cartels smuggle for me to fill this up...smh

 

[dwcraig1]

I fill my boro tanks out of the mod. I prefer a boro with sliding glass BTW. When finishing filling I hold it in a napkin or paper towel with the top down and with a "slinging" motion expel any surplus juice. It works for me.

 

[crss]

Sunday Kbron

 

[badinfluence357]

I hope some of you were able to score some of those rare collb Odb battery wraps.. it's definitely worth taking a look at..

 

[crss]

odb

 

[BillW50]

Unbelievable! That's a 210 watt battery.

View attachment 1018908

OMG! Mooch pushed it to 100A.

Bench Test Results: EVE 40PL - 70A 4000mAh 21700

These tests below only note my personal opinion for the ESTIMATED ratings for the batteries I tested at the time I tested them. Any battery that is not a genuine Samsung, Sony, Murata, LG, Panasonic, Molicel, EVE, Lishen, BAK, or Sanyo can change...

www.e-cigarette-forum.com

 

[badinfluence357]

New battery's, New wraps.. A friend traded me the Bleed Sturdy wrap, and I'm so happy he did. Its a cool looking wrap...

Im still waiting on some more ODB wraps I just picked up...

 

[badinfluence357]

Im lloking for a Iceberg Dot Mod..Maybe someone knows someone that stock piles and by chance they may have an extra one.. I don't think so, but damn I want one bad..

 

[crss]

D100c landed, quick strike luck.

 

[ShamrockPat]

D100c landed, quick strike luck.View attachment 1019263View attachment 1019264View attachment 1019267

Ooh, that's interesting. What are those 3 horizontal circles, I'm guessing just more airflow, and is it a lipo mod? Their themes are usually loaded with all sorts of carp images.

 

[crss]

It is air flow for boro. There are images in the theme. Lipo it has. New panels arrive today.

 

[Tor R]

I hope some of you were able to score some of those rare collb Odb battery wraps.. it's definitely worth taking a look at..

My package seems to have disappeared over the little pond between the UK and Norway.
So right now it's no

 

[ShamrockPat]

It is air flow for boro. There are images in the theme. Lipo it has

Thanks crss, a typical Delro. Enjoy!