BreezEsmokes Has the Version 2 510 Juice Tanks in Stock!

Status
Not open for further replies.

butterbean03

Unregistered Supplier
ECF Veteran
Mar 17, 2009
1,388
84
Central Texas USA
Yep, a different version of the original 510 juice tank has arrived and both Versions can be seen here.

Go to product page and look toward the bottom and click on Detailed Images to see a close up.

Theory is when you inhale, juice tank creates a vacuum and pulls juice onto atomizer
almost like dripping.

Can be used with or without polyfil. Notice the hooks on the removable plate.

Can be turned upside down and add Blue Foam.

Also added Blue Foam to the mouthpiece. Maybe not necessary. Just a mod I did
to show how to prevent juice getting into your mouth. Have not had this happen.

Bottom and top pieces snap off and on for cleaning and refilling.

510TankA_B.jpg
 

butterbean03

Unregistered Supplier
ECF Veteran
Mar 17, 2009
1,388
84
Central Texas USA
HERE ARE A COUPLE OF PERFORMANCE TIPS FOR YOUR eGo-T TANKS.

1. Take the vapor restrictor out. Take a paper clip and pull the plastic end of the mouthpiece out with the hole in it. Next look down in the mouthpiece and you will see a plate with a hole in it. Insert your paper clip and pull it out. If you are able to leave both of these pieces out without getting dirt down in there, leave them out. You will notice a difference in vapor. If not just put the top plate back in and leave the inner plate out. The vapor is trying to get through 2 small holes and causing a restriction.

2. If you are using the original eGo 3.3v battery or any 3.3v battery, try going to a 3.7v battery. My Riva and KGO's both use 3.7v batteries. There is a noticeable difference in performance especially with a newly charged 3.7v battery. The main problem I see is that the coil is not getting hot enough.

3. Instead of using a syringe to refill your cart, the hole where you refill your cartridge is a small plate that will pop out. Best not to use the paper clip because you can distort the hole and it will start leaking. Use your fingernail and find the little tab sticking out and push it out. Pop it out and use a dropper bottle to refill. Also while you have that plate off of the cart, look at the bottom side of the plate and you will see the hanging chad from when you punctured the cart for the first time. Take a pair of tweezers and pull it off. Refill your tank and snap the plate back on and insert into atty. You are ready to go.

These may have already been covered elsewhere, but I found these are just a couple of things you can do to get better performance.

Of course when manufacturers start getting negative feedback, they start making changes. I am having good luck with mine doing these things and then again I have only had mine in stock a couple of weeks and have the latest available. Or maybe just lucky!

Don
 
Last edited:

butterbean03

Unregistered Supplier
ECF Veteran
Mar 17, 2009
1,388
84
Central Texas USA
Clearomizers back in stock.

Also got eGo-T 3rd generation kits with case. Will have them up by late this afternoon.

And along with that came EM LR attys including 801's. Got more Auto plugs, colored aluminum Drip Tips and chrome Drip Tips.

Should have the biggest part up by tonight or this afternoon.

Don
 

butterbean03

Unregistered Supplier
ECF Veteran
Mar 17, 2009
1,388
84
Central Texas USA
I will put them up in a little bit, but they are 900mAh batteries with an upgraded cart and atomizer I was told. These are Joye's because they are identical in looks. They are unbranded, but I just got them in this morning and have not even tested them. I got them from another company that buys Joye items. Looks like they just don't have the "eGo-T" brand on them also. Other than that they look like my originals. And because of that they are less expensive. That's the best I can do until I test one in a few minutes.

They come in an original eGo case also.

Don
 

Dougiestyle

Vaping Master
ECF Veteran
Verified Member
Feb 5, 2011
3,213
3,960
51
Knoxville, TN USA
No, they don't replace a juice cup in a cart. Not sure what you are talking about. These are the carts. This is a translucent 510 juice tank cartridge.
I've taken one of my Mom's cartridges apart, and the "cup" I'm talking about is inside the white tube that slides over the atty. It's perfectly round with the hole on the opposite end from the atty. The "cup" is flat on the side for the vapor to go past from the atty to the hole. The pic of your tank cartridge looks like it's flat on the side, thus disabling it's ability to fit over the round atty body. Maybe I'm just looking at it wrong? It seems to be shaped the same as the innards of my Mom's cartridges. If it's round and fits over the 510 atty, I'll be ordering some. TIA for clearing up my confusion!

BTW Mom's kit is the Volcano if that matters.
 

butterbean03

Unregistered Supplier
ECF Veteran
Mar 17, 2009
1,388
84
Central Texas USA
Hey bigtime, will study it a little bit more tonight and let you know. The eGo-T's I got a couple of weeks ago are working fine. But I am using a 3.7V battery and so far so good. Didn't think .4v would make that much difference.

Now I went back and checked emails and they said this battery now puts out a constant 3.4v right up until it dies.
Just the response I got.

Don
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread