The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Building on my Dark Horse RDA (Clone)

Discussion in 'Cloud Chasers' started by gmx1994, Dec 30, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. gmx1994

    gmx1994 Full Member

    Dec 30, 2014
    North Las Vegas
    I have a J2P Silver Dragon Clone and a Sigelei 100w v1. I was running both with same tank on 24g nichrome with 5 wraps until last night the coil snapped. Now I am looking to rebuild it but with Kanthal A1 28g. Is that a good move with 5 or 4 wraps. I want nice big clouds. What do you guys recommend as far as building with Kanthal a1 28g. And should I twist it for better results?
     
  2. SLIPPY_EEL

    SLIPPY_EEL Vaping Master ECF Veteran

    Oct 11, 2013
    Ω England Ω
    yeah maybe 3 strands of 28g twisted up together will get you close to the 24g you had installed previously.:)


    i dont know how advanced you are but you can also flatten the twisted wire a little as shown in this following vid but you dont have to use two strands of the twisted wire in your coil to make a parallel build, the reason i say this is becouse it will make your ohms really low even with just the one coil, hope this makes sense and i hope you have a multimeter>> https://www.youtube.com/watch?v=6Aml3pJlCEQ

    here, i may aswell give you this link while im at it, on wicking your hot builds for clouds>> https://www.youtube.com/watch?v=M1hqRp9TDDE

    Goodluck :)
     
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice