Bulli A2-T

[AlmightyGod]

Some mesh builds for the Bulli A2

 

[Cid78]

Almighty, when you set up Bulli to become a genesis bottom coil atomizer, does it leak? I got leaking from the tank, not sure whether it is leaking from the spike hole or over wicking.. But i keep sucking juice from it

 

[AlmightyGod]

The second pic was to use it as a dripper.

If you want to set it up with mesh & use the tanks, it requires a solid core wick. It's much more difficult to set it up this way. I use the horizontal coil in the first pic for tanks. The key is the spike wick. You have to get it just right for the thickness of your e-liquid.

 

[Richard75]

I've been messing around with my Bulli A2-T for about a week now, and I must say once you get it set up right, it's a heavenly vape!

My only concern (and question) is about e-liquid getting into the base... I have the version with the closed connection, so it doesn't leak from the bottom, but liquid still gets in through the negative terminal (the one with the brass ring). Since it's a closed connection, I can't blow it out; I've just been letting it soak out a little at a time when I clean and replace the coil. Will this damage the internals of the Bulli at all, or is it not something to worry about? Does anyone else have this happening, or is mine just a bit quirky?

 

[AlmightyGod]

I had the connector off of one mine (unintentionally) and even if liquid gets in there, it's not going to hurt anything.
There is a single wire for the positive connection, and it is epoxied over, so there is no chance of a short.

 

[Cid78]

The second pic was to use it as a dripper.

If you want to set it up with mesh & use the tanks, it requires a solid core wick. It's much more difficult to set it up this way. I use the horizontal coil in the first pic for tanks. The key is the spike wick. You have to get it just right for the thickness of your e-liquid.

Yes, i realize that the main point is the wick that go through the spike.. Now i do not have leaking anymore after playing a bit with it.. Still using 2 silica wicks for the spike wick though...

Thanks for your input Almighty, will try to do with SS mesh wrapped around silica.. so i need to oxidized the mesh before wrapping it around the silica, isn't it?

 

[AlmightyGod]

Yes, i realize that the main point is the wick that go through the spike.. Now i do not have leaking anymore after playing a bit with it.. Still using 2 silica wicks for the spike wick though...

Thanks for your input Almighty, will try to do with SS mesh wrapped around silica.. so i need to oxidized the mesh before wrapping it around the silica, isn't it?

Oh yes....just a quick torch job should be sufficient.